- Another alternative for the Zinc deprived
- Seat motor runs but seat won't move
- Code 55
- Finally arrived.
- Rear end weight
- Need advice for battery replacement
- Removing Window Tint
- High idle.
- Need some torque specs.
- Fuel pumps
- Clutch Pressure Plate Bolts
- what is the white .....
- Muted radio
- Injectors
- Service (SIR) Supplemental inflatable Restraint
- Q: Removing 2ndary shafts?
- Popping noise from rear
- Rear wheel bearing
- overheating/ thermostat change
- Idle Valve, Is this a common GM Piece?
- Tired of busted vacuum hose (aka spider)
- Oil Catch Can Results
- recoating/plating stock top end bolts anyone done it?
- Radiator hose ??s for you guys w/ LT1/4 cars
- Cam Cover Torque and sequence
- Header install tips and tricks??
- Dielectric grease
- Fuel injectors
- Why do you need an oil catch can?
- 1994 Spark Plug gap
- New Injectors
- What is this thing?
- What is it?
- Rear Tires 315 vs. 335
- If you use a batter tender come inside...or if you really know electrics
- Non ZR-1 Dyno graph help
- 1990 driver's seat recline stopped working
- Plug readers step in
- EGR system
- QUESTION REGARDING A/C COMPRESSOR SHELF LIFE
- Thermostat
- flashing "sys", blowing fuse
- ABS is dead
- Belt Tensioner
- ZR-1 Valet Switches
- basic questions
- C 4 Frame tiedowns
- Horsepower
- Help with ZR-1 wheels from fathers estate.
- Video Tool
- Raising suspension after its been lowered.
- Service Ride Control
- Selective Ride Control
- replacing the amplifer relay
- LTPWS change from 93 to 95 wheels
- Question about catch can, specifically on a '90
- Those with FIC injectors
- ZR1-93
- Change Oil Light Reset Procedure
- Back up light
- Dipstick question
- Which injectors to choose
- Crank engine without starting
- car is running now. but have an oil problem
- Horn electrical diagnosis
- New shocks
- service engine soon light
- Broke thermostat housing bolts
- "Pads" on targa top? wth?
- Not starting>>
- Extrude honing
- Idle Air Controller Trouble Shooting - need help
- Starter question
- Throttle body plate
- Can You Re-Use Main Bearing Cap Bolts?
- Machining plenum/inj ect.
- Machining plenum/inj ect.#2
- Steering Wheel Align?
- Broken Thermostat bolts update
- Injector machining done.
- main bearing cap bolts
- Fuel injector question
- Throttle body top plate
- Shift Light Install
- Stock Catalytic Converter
- Dipstick Tube Seal Group Purchase
- Vacuum Leak
- Fans come on with key in "on" position
- Brake master cylinder question
- Swapping the LT-5 into a '69 Camaro
- Headlight motor battery draining
- B&M Shifter Removal ??
- where can one buy a 1/2 shaft
- 1990 dash lighting problem
- Miss After Heat Soaking
- Q for you bore n stoke boyz
- Valve Spring Tool
- Code 24???
- ID these injector housings
- SYS message
- Injector Help
- Ready for the oil catch can...
- low oil pressure
- Rear Window Replacement
- More Power!
- Eureka!!!!!!!
- Oil cooler lines
- I'm i doing this right?
- Clutch master cylinder line
- Steering column
- Correct engine coolant temperature
- Throttle Body expansion
- Arggg... Help!
- Oil Leak
- Tire pressure sensors.
- Clutch Fluid
- Is the ZR-1 clutch line the same as a 91-96
- New York Emission System option?
- Cleaning Plenum - Any New Ideas
- Passed Exhaust Emissions Test
- Air cleaner housing
- Cam cover bolts.
- Oil pan removal advice
- Need some clutch help
- Ebay part test # 1 ECM/CCM Holder
- Ebay part test # 2 IAC Valve
- FX3 actuator
- Help-no start
- Source for Head Gaskets
- Pump cycling with key on???
- Got it running -- hesitates when cold
- Oil Pan gasket for 94
- Electrical Connector Repair
- C60 A/C Help
- Lowering a '91 ZR1
- Fuel filter changeout?
- Removing steering wheel.
- Change Oil Light
- building for SCCA Solo BSP
- Knock Sensor; What happens if its disconnected
- Next Performance Modification, 90 ZR!
- Backfire Question
- question on Amps and speakers
- Cooling system bubble?
- There, I fixed it
- Stupid question about lugnuts
- Brakes
- To Replace the Rad or Not Replace The Rad?
- Body moldings
- Hurst Shifter Installation
- Low volt when A/C is on
- Kind gentlemen...need help on shocking issue>>
- Non-operating Secondaries Repaired
- CCM
- Upshift Solenoid unpluged Why?
- Clutch Replacement
- Plenum coolant circulation Q's
- "Z51" on the ZR-1...
- The porting is over
- Traveling ZR-1 New Owner could use some help
- No or low spark #4 and #7 plugs
- Catalytic Worn out?
- PCV connector
- C5 brake upgrade on my 91Z?
- C6 Z06 wheel/tire
- Half Shaft Removal
- a whole load of issues
- What's wrong in these pictures?
- catch can update
- 1st LT5 Engine Pull, Looking for Tips and Tricks
- Need help understanding scan data
- Excellent DA Calculator
- Running rough
- Fixed a Secondary System Vacuum Leak
- Valve cover bolts.
- Halo trim squeak
- Question about EGR connection to long tube headers
- Pulled the plenum, now what?
- Rough Idle/Hesitation/Backfire
- This fall
- Crankshaft plug...
- Rear tie rod
- Custom options
- Now its my turn.
- Porting Brain Trust, Help!
- Antifreeze leak
- Crankshaft rear oil seal replacement
- Rear Spring issue
- FBI stuff: 368 up grade?
- Suspension Question.
- Replaced Radiator and Thermostat
- Pilot bearing puller
- How to fix burned-through floorpan?
- ZR-1 Ten Commandments
- Name that Noise>>
- Diagnosis for Whistling noise
- Help Identify a fuse.
- Speakin of "running rough"...
- Flushing out fuel rail
- Flow testing.
- Throttle Body Secondary Valves
- Secondary Vacuum Solenoid
- Bilstein shocks
- 368 sleeves and pistons??
- Flywheel Removal
- What is the weight of a stock piston?
- Found a great replacement for the headlight gear inserts!
- Nitrogen gas additive
- Q on attachement for LT5 pull...
- rear brake lines rub the wheels
- Help please with clutch master cylinder
- Rear Spring Issues Pt 2
- HID Xenon Driving Lights -How to..
- Temp gauge inop
- Removing Secondary Vacuum System questions.
- Finally powdercoater bound.
- spark plugs for a full top end ported engine
- C-beam Remove and Reinstall
- Crankshaft rear seal didn't fix the oil leak
- Heater Core. Another fun project
- Steering shaft rag joint
- ??? 1990 ZR1 offsets
- Engine Starvation / Fluttering
- why the different plunums
- Bought A 94 LT5 With Known Problem
- Belt Tensioner
- Brake Fluid
- Noise from the rear
- Secondary failure on one bank/drag racing
- Adding sub/amp to factory Bose
- exhaust gas temperature, flow, and volume data
- Seat question......
- Header Stud
- Clutch Pedal to the Floor
- New Day New Problem
- Oil Cooler Lines
- PLUG recommendations for 95 ZR1
- Difference in '90-92 brakes vs '93+?
- Proper PS procedure
- clutch fluid empty overnight
- What happened?
- Waxers: step in; need advice
- Clutch pedal effort
- Stiff gas pedal
- A hurt valve...
- Tech 1A
- Oooops!
- Cam Cover Foam Filters
- help needed at carlise
- What spray paint to use?