Clutch master cylinder line

[LGAFF]

Anyone know who has these?

[lbszr]

Saw a stainless flex one, but don't know where it came from:dontknow:

[Pete]

Lee,i took mine to a place near me and rebuild my line for around $60.

Pete

[-=Jeff=-]

have you tried?
http://www.tld-corvette.com/products.asp?dept=905

they show them there

also at Corvette America

http://www.corvetteamerica.com/cf/displaylearnmore.cfm?learnmoreid=329&idlist=74,107,179,178,4433,204,264,263,328,329,179 ,178,4433,264,263,237,269,328,264,263,237,204,3394 ,328,3538,3531,3293,329,378&searchdest=%2Fcf%2Flearnmorelist.cfm%3Fsubcategory id%3DX735&subcategoryid=X735

[LGAFF]

Lee,i took mine to a place near me and rebuild my line for around $60.

Pete



Pete where did you have it done....better than $150

Thanks

[Pete]

Here it is.
http://www.geibind.com/contact.htm


Pete

[LGAFF]

Anyone have the fitting sizes for this? Looking to have a line made.

[XfireZ51]

Lee,

If you get the correct hose fittings, we can make them fairly easily. I made my fuel lines
on the 84.

[LGAFF]

Pegasus racing has pre made but only standard, with -3AN or -4 AN lines, need to know the flare fitting sizes to get a male adapter...also need to find meteric I assume.....you can get a premade line for about $28, plus cost of male fittings.

[LGAFF]

Well it appears the fitting is 12mm but I am not sure of the thread pitch went to autozone and True Value, all they had was a 12X1.25 and it would not go.


So either the male adapter is a M12 X1 or M12 X .8

Please let me know if anyone knows the size.

[LGAFF]

If I use a Male 12 x 1.0mm Metric Convex Seat to 3AN Male connector then use a braided teflon brake hose, I assume this would work as a clutch line. The cost would be $16 for the fittings and $26 for the hose....does this sound correct? I am guessing I need about 30-32" of line.

[LGAFF]

After a long wait, got my line today...stainless steel and formed lines, same as OEM...very nice $85 plus $10 shipping.