- Looking for Help
- Flow sheet/fixture for flowing heads?
- Welding Cat-Back Exhaust.
- No Am Reception
- Mat relocation kit
- Getting Hosed
- Camshafts almost done
- Weird interference issue with plenum installation
- TB coolant crossover,any disadvantages?
- ZF reseal
- Power Antenna Mount Questions>>
- Clutch Replacement Issues
- Potential Sources for New Lifters
- 1991 ZR-1 Missing on Cold Start
- Coolant
- Radio/Speaker Experts
- LT5 Bolt, Nut & Washer List Update
- Rear Swaybar
- Idle Flare UP
- Checking Codes
- Some new parts available
- Looking for source of PROM
- Removing TB Butterfly Plate Screws
- Clutch Adjustment
- Sealant for window seals
- C5 Z06 Brakes Conversion
- Clutch Engagement
- Throwout bearing.
- Driveshaft Q
- Cam specs for Ported Heads
- Vibration
- Oil cooler lines
- Z wont start
- Flowmaster Cat Back
- 91 Z not firing on no. 1 cylinder.
- What about that accordion?
- Question for all you engine guys lt5 zr1
- trans etc...change-out questions
- Off idle stumble.
- Inlet length tuning
- tech 1 manual
- SHelby Wheels and C5 brakes>>
- Leaking Waterpump?
- Intermittent Code 61 Ideas
- Blue Smoke
- oil filter
- What is causing this oil smell?
- Want to run an ITB manifold. Has it been done on a LT-5?
- Oil Pan Gasket - OEM or Jerry's?
- SYS codes
- SYS light,,
- Bad brake fluid?
- info needed re clutch refit
- Intake accordian took a dump,fuel tank, rah, rah
- Injector jerry-rig?
- Plenum Paint Bubbles
- Opinions needed.
- Transmission "clunk"
- Ok, I ordered my headers from ss
- 200mph ???
- Looking for a rear suspension bushing recommendation
- Will C5 brake rotors fit
- Great help.
- Race Fuel ?????
- need help identifying sensor pn
- New clutch.
- ok tearing apart the ZR-1 for paint
- Can I live with these injectors till Fall?
- Anyone Switched Seats?
- Rusty stain at rear of block/heads?
- Received my headers today
- 1/2 way through 1st plenum pull
- Sea Foam Motor Treament
- Cleaning Engine
- Radio Antenna
- MagnaFlow Exhaust Fitment
- C6 Z06 wheel alignment
- Car didn't start
- Hard start
- Ceramic coating
- Stereo trouble
- Lights Out
- Rear Suspensiom Ride Height
- "New" seats!
- Constricted Header Collector?
- For those asking about hatch shocks
- Fast Idle
- Compatibility of '92 chip? 90-91?
- Ignition / No Start
- "FBI" News flash!
- sealant needed on water pump gasket or other gaskets?
- When is a clutch slave cylinder not a clutch slave cylinder?
- Monday bloody Monday
- Group Buy on Beam Plates
- Few ?'s for the true guru's on the forum
- LT5 Head Gaskets
- Dip Stick help.
- What to do?
- So, Pete...Kev's 441 tuning?
- Upgrading ZR-1 Front Brakes to C5/C6 brakes
- Source for shorter flywheel bolts
- What did I find in my oil pan?
- Fram TG3985 filters found
- SHOCK to SHOCK-TIME TO ROCK!
- Mis Fire and Back Fire
- Smog problem
- Service engine soon
- rear roof bolts not grabbing?
- Intermittent Code 63 Ideas
- ** TQ specs Please? **
- heater part two
- Plenum Pull - Anything Else I should do?
- Looking to borrow,rent a Tech 1 scanner.
- Looking forward to my commute tomorrow
- DRM Coilovers,PICS ! Wow why the hell did I wait ?
- Removed secondaries, now code 55 and 64
- compatible parts from normal C4's
- Getting ready for the big yank.
- Idle Troubleshooting
- Mini-pull
- Door lock and security alarm
- Crank position sensor trigger wheel
- clutch disc pic please
- Dyno sheets
- Alternator
- Paint removal
- Header install questions.
- Dang! Bad went to worse!!!
- Where I am at so far..
- This is what it's all about.
- This is what it's all about 2
- Big Bore LT5 builder
- Door panels pulling off - solved!
- Clutch Slave Cyclinder
- It's back on the road again.
- Re-torquing Spark Plugs
- cam cover ????
- Potential Cooling Fan Problem
- A Good Shop In Pheonix area?
- Shelby Series 1 Wheels fitment
- Where can I get
- What is the weight of an LT5 engine?
- A question about the Tech 1 Scanner.
- Slight Hesitation
- 1991 Fuel Injectors
- Any Tuners that can comment on these tricks?
- Correct NGK for a 90-92 Car?
- Hy-Per Lube ??
- Coolant Hoses Available
- Half Shaft ?
- Paging Marc Haibeck: Cams
- Starter parts?
- Flywheel check?
- ABS ASR Lights coming on
- Does anyone know what part this is?
- passenger seat won't go back and forth
- Porting a stock LT5
- Code 42 where are you....
- Rear Caliper Rebuild
- Dana 44 gearsets
- Oil Dipstick
- Is this connector on the + pos battery cable available separately?
- Fuel Pump
- Throttle body coolant bypass
- Powder Coating the Throttle body?
- Asking for help with noise (clutch) diagnosis
- Haibeck PROM Idle
- Having Trouble Need Suggestions
- HID - Any opinion?
- Wheel house body panel screw/bolt
- 91 ZR-1
- ZR-1 Block Numbers
- Help with engine tune problem
- LT5 cam timing
- Cam timing LT5
- Strange Leak
- Emissions -- Bah Humbug!
- EPROM
- Replacing tie rods.
- Plenum tools
- Tough VA emissions - need help
- Polishing zinc coated billet aluminum ????
- Can ANYBODY help a brother out,ABS is dead and I give up.
- Heading into the home stretch!!
- High coolant temp
- cooling fan ralay
- An Idle Discussion..
- pipe on drivers side of plenum
- Haaalp! Need phone # asap
- A/C Diagnostic Mode
- Coil packs
- 90-93 Seat Mod - its Comfy Now
- ujoint part#'s
- Torsional Dampner Installing Tool
- Rear End Snubber Extensions for Drag Racing
- LT5 injector set-up with programmable ECU
- new from nj.LT5 swap
- something to watch for when .....
- Belt tensioner going bad?
- Fidanza Flywheel what Clutch ??
- Tech Data Category
- Finally passed emissions!!!!
- More smog problems
- Rebushing the whole car.
- Rebushing the whole car #2
- Fan Temperature Switch?
- plugs
- Anyone seen these parts
- Hesitation when secondaries engage?
- Rebushing #3
- Rebushing #4
- Dead coil,could it be the spark controller?
- Rebushing #5
- Rebushing #6
- Twin turbo LT5 engine for my Camaro
- what the hell happended ?
- Question about installing front cover seal
- CLUTCH - NO MORE!
- Any ideas on where they ran the satellite radio antenna cable!!
- Breather tube removal from IH
- How to replace motor mount covers (heat shield)
- Spring Rates
- Rear rebushing done.
- Rear rebushing #2
- Rebushing the rear #3
- To all coil over guys.
- A Couple New, Unrelated Issues
- Cylinder Head Secondary Shaft Bore Plugs
- Rear diff sealant.
- Factory production date markings ?
- help on keys
- need new clutch M/S
- ATI Torsional Damper
- Interior and trim
- Interior Door panel question
- Trans Third Gear Shift / Fluid
- Wide band sensors and shift lights...
- Floppy DS headlight
- Emissions Test Success
- More questions on the new ZR
- U Joint Strap Bolts
- Instrument Cluster
- Brake Master Cyl. Woes
- Recommendations for lifting ZR with shop hoist
- something goofy here
- My first attempt at timing the LT5 camshafts
- AO Forced Air installed instructions
- 1990 ZR1 passkey system
- Trouble code list for 1990
- Electronic A/C diagnostics procedure