- Marc Haibeck saved the day!
- Porting the heads now...
- Left side Coolant fan issue
- Food for thought.
- Rear Wheel Bearings
- bad stutter at 2000 rpm, only power key on
- Rear Knuckle Failure
- Water Pump Removal
- head bolt question
- Pod Gauges
- First class welding.
- Running Rough. . .
- ? about after the trans is removed (weight of engine resting to rear)
- Starter Motor Harness Connector
- Paint work
- Header install
- DS Cam Cover removal time cutting step
- Thermo-tec
- Question about the coils how to test?
- Aluminum Power Steering Pump
- *** PLEASE HELP ***
- Quick Q: Clutches...
- Another aftermarket clutch and flywheel question
- Another Water Pump Post
- DIS control box Q
- Name the fastener size
- Installing HID Driving Lights
- DIS module broken, Where I could get new/used..
- Motor died while running, now no-start
- Curious about fuel pump grounding
- Clutch order today: chk me out...
- quick Water pump Gasket question
- fuel pump problem or what
- New option for fuel pump replacement
- TB Plate Gasket
- Question abou my 1990 ZR1.
- What are you using to install harmonic balancer/torsional damper?
- Headers Installed
- Water Pipe Gaskets Needed
- Courtesy lamp fuse keeps blowing
- Camshaft timing findings
- Factory Reproduction Wheels
- Heater hose - Is this right?
- Secondary Vacuum Pump Question
- Weird (?) AC problem
- Interesting LT5 ECM Set-up
- What causes catalytic converter damage?
- Alternator or Battery???
- 3-angle valve grind vs. "standard"?
- LT5 Bellhousing Interchange
- Radiator
- 335x30x18 tires
- GM Connector Info Site
- Plug Wires
- Any results on Siamese vs Ported intake
- Alternator Rebuild
- clutch slave master or slave cylinder?
- Rear Leaf Spring found starting to splinter
- o2 sensor code 45
- Engine missing
- Odd Fan behavior
- what other engines will a ZF 6 speed fit
- TECH 1 CARTRIDGE QUESTION
- Brake rotor/pads
- Started taking apart the bottom half
- Are connecting rods/caps stamped from the factory by cylinder?
- do these brake calipers and rotors fit our cars
- Analog water temp sensor stopped working
- Need some ideas.
- Life is good.
- Injectors
- Service Ride Control Code 14
- Gas tank replacement
- 90 zr1 front arm bolt how to remove?
- 1 Cyl miss, out of ideas, might sell cheap..LOL
- Starting question
- 1991 injector question
- Throttle Plate Corrosion/Gasket
- The search for DAG.
- Need help on replacing B&M with a Hurst shifter
- Considering a 368 build, where do I buy the components?
- Watson header install advice
- Brake fluid question
- Brake Rotors/Calipers and cleaning
- A video training module on electronic transmissions
- Front Upper Control Arm
- e brake not working
- VSS (Vehicle Speed Sensor)
- Diff ?
- Alternative for spare tire
- What is the best oil for the beast.
- Starting winter project, have a mystery wire
- Another 1991 Fails CA emissions... Help!
- McMaster Carr cap screw part #s?
- SES light ?
- Differential Case
- My clutch issue
- Speaking of Clutch Issues
- Sway Bar Brackets Needed
- Backup lamp switch pin size
- What size allen wrench do I need for the Transmission oil fill/add bolts?
- Exhaust system question
- Clutch Fluid Options
- More on Z06 Wheels
- Side Bolsters
- Intermittant No Start
- Exhaust manifold
- Radiator shroud
- Oil and ZDDP
- What kind of power are the big LT-5 race motors making?
- Doing head gaskets
- SS BRAKE LINE FOR BREMBO BRAKES
- Diff Question
- Leaky Radiator
- Vacuum pump not coming on?
- Compression Tester?
- Coilover Spring rates
- Is the liner installation and retainer kit a must to install liners?
- 427 coming along
- Bose Speakers
- Camshaft Questions
- Sometimes don't start
- Rear Noise
- 1994 Mufflers
- CPT videos
- Stud Kit for Cylinder Heads and Main Bearing Caps
- Idle concerns
- connector part numbers needed
- Speedo Gear info
- CHASSIS ROT and other stuff
- 30MM Sway Bars w/ FX3
- What is the largest CI that LT5 can be built to with stock crank?
- Need Vacuum pump PN-90Z
- Lumbar pump question
- Remove door panel
- Power steering hose part number
- Mahle Rings
- Braided Clutch Line
- Tuning folks, would this stuff work?
- Differential Question
- ECM bracket
- My Most Excellent Z06 Wheel Adventure
- NEED SOME INSIGHT
- Seat repair
- Seat Control Trim Plates
- Shock bushings - Need help!
- Replacing Injectors Soon
- Weird... car dies and won't even crank. Then starts like nothing happened.
- Thickness of water pump gasket??
- Power key problem
- Paging Jeffvette/Fikse barrel swap
- Locktite cleanout??
- Finishing touches to head porting...
- Master Cylinder Connector
- BYPASSING THE FULL POWER KEY AND SWITCH
- This is why you fill your tank up
- X-pipe exhaust question
- Looking for advice on these differential bearing caps
- How to install speedometer correction gears
- NO HEAT
- 93-95 LT5 Long Block?
- Fikse FM/5 wheel owners jump in
- power steering noise (maybe)
- CMHSL LED install on my ZR-1
- Trying a new bit for porting.
- DAMN GM and their different castings
- Socket Size for Balancer Bolt
- Success at last!!!! (I hope...)
- coilover spring adjusting whats....
- Tuning related question
- NAPA Clutch Mst & Slave Cylinder
- Where to get window seals?
- Jump Starting
- What is an LT5 worth ??
- Clutch Hydralic Hose Built In Restrictor
- Disconnect Secondary
- Alternator replacement?
- Ball Hone
- Doing engine assembly, sealant application quantity needed?
- ATTN: Jagdpanzer RE: Exhaust
- Viper Gears and Part #s
- Front end alignment
- So who is first ?
- intake port molds
- Intake runner optimization calculator
- clutch master cylinder reservior
- 2 Questions?
- Header, Exhuast, Gear Combo
- Help identifying an A-mold wheel
- Samco Hose Question
- Clutch issues
- rear wheel bearing removal.
- Not good.
- '91 missing and would like a second opinnion
- Hard Starting 92
- Rear Tie Rod Ends
- whats an LT5 worth ? update
- ZF 6
- Rear Suspension Pictures
- Carolina Stage 2 Clutch-Anyone used it?
- headlight door motor
- RC Primary and Secondary difference
- Changing out injectors 1990
- Poor mans two post lift.
- ZF 6 speed
- 3:45's vs 4:10's MPG
- rookie question
- help please for a new member
- Clutch break-in & Tac error Qs?
- Any ZF-6 transmission label experts out there?
- ARGH! Wrong clutch disc...
- I'm so relieved.
- LTPWS Receiver
- Interesting read on open dec on Porsches
- steering anomoly
- If i ask a dumb question will everyone please make fun of me ??
- Not another transmission question............
- Crankshaft Position Sensor Bolt
- My first plenum pull!
- Where to find a Torque Honing Plate
- New injectors installed and now it is slow to start.
- How many different vacuum kits?
- two unrelated questions
- Bilstein project revalve and more info
- Water/Methanol Injection...
- Further Block Tear Down (no pictures)
- Whats going to go out first,master cylinder or slave..............
- P&P toys
- Header Bolt Battle
- Plug wires
- Differential Lube addative?
- stock exhaust removal
- 170 stat owners what temp....
- Extra mouse power
- Cyl head flow.
- Battery drain
- Removing Cam Cover Bolts
- Past oil leak
- Looking for Help
- Flow sheet/fixture for flowing heads?
- Welding Cat-Back Exhaust.
- No Am Reception
- Mat relocation kit
- Getting Hosed
- Camshafts almost done
- Weird interference issue with plenum installation
- TB Coolant Crossover/Bypass, Any Disadvantages?
- ZF reseal
- Power Antenna Mount Questions>>
- Clutch Replacement Issues