clutch disc pic please

[hihok9]

Installing my clutch disc with hydraulic throwout bearing and had no old one to go by..... Assembly manual is not clear and RAM directions are poor..... anybody got a pic of which side goes toward engine. Don't want to make that mistake. Thanks!

[Wide_One]

Are you replacing the slave cylinder with the ram kit?

[rhipsher]

Here you go.
http://i301.photobucket.com/albums/nn63/keeno1970/Clutchjob039.jpg

http://i301.photobucket.com/albums/nn63/keeno1970/Clutchjob038.jpg

http://i301.photobucket.com/albums/nn63/keeno1970/Clutchjob033.jpg

[A26B]

I think he wanted photos of the disc.

[rhipsher]

I think he wanted photos of the disc.oops. that's easy enough without a photo. most disks have a sticker that says flywheel side. Look at your disk where the 26 tooth spline is. One side is flush with the face and the other protrudes about an inch. the protruding side faces your flywheel/engine.

[hihok9]

Thanks! That's what I was looking for. There is a small collar on the side I put toward the engine.... maybe a half inch... and the side toward the tranny was a couple flat plates maybe 1/4 in wide six inches across, wide and smooth, not like the collar on the other side. The slave is the throwout, uses the stock firewall master. I had to cut the boss off the bellhousing for the slave to make clearance in my application. The hydraulic system came with aluminum flywheel as well. That's when I found out all about having to get shorter bolts ..... Learning as I go.