Received my headers today

[todesengel]

the welds look good, but I am going to mill the flange flat. They have a few places that are high, and would rather not risk the leak. Overall look nice.

Wonder how much skin and blood I am going to leave on this thing during install....

http://i13.photobucket.com/albums/a260/chaosrob/DSC_0591.jpg

[-=Jeff=-]

test fit them before milling...
just in case

[phrogs]

also there are not bolts in every hole on the stock headers so if you want you can also bolt them up like that.

Or you can install a bolt in every hole just don't be suprised when you look up and see that they all do not have bolts in them!

How much were those because I haven't see them set up to use the cats thats pretty neat my last set didn't have the cats and this is newer tech!


also to save some blood it helps to have off the wheel wells so you can gain access more on the passenger LH side but blood will be lost at least once.

[GOLDCYLON]

the welds look good, but I am going to mill the flange flat. They have a few places that are high, and would rather not risk the leak. Overall look nice.

Wonder how much skin and blood I am going to leave on this thing during install....




Pull the inner fenders it makes the job a lot easier. Also I agree test fit before you mill anything. GC

[WB9MCW]

SWEEEEEEEEEEEEEEEEET