Recommendations for lifting ZR with shop hoist

[Don in VT]

Hi,

I have searched the forums and I cannot find any info on lifting our 90 Zr with a shop asymetrical or finger type hoist. I lift my 87 all the time but the pinch welds are not the same on the ZR. Over the years others have used lifting that got into the foot wells. I do not have a ramp 4 poster lift available. The finger lifts are better anyway.

Thanks

Cherry and Don:proud:

[WB9MCW]

http://www.zr1.net/forum/showthread.php?t=4478&highlight=jack+points+zr-1&page=3

Scroll down to the 2/3 page and look for A and B photo.

oh and if you are asking about the factory jack point, it's between the two molded in "arrows" there in your picture. Rear a bit from the "B" label.

http://i17.photobucket.com/albums/b79/MRBLU/ZR1FrntJackpoint.jpg

[Don in VT]

Thanks everyone. Problem solved