Forum: C4 ZR-1 General Postings
10-18-2021
|
|
Replies: 21
Views: 2,150
Re: Antenna Bezel Replacement
After having replaced the mast (had to remove antenna motor to remove broken plastic pieces), I decided to try using the standard C4 bezel. It works okay, but it sits a little high compared to the...
|
|
Forum: C4 ZR-1 General Postings
10-07-2021
|
|
Replies: 21
Views: 2,150
Re: Antenna Bezel Replacement
Going to see if I can fabricate something from grommet material. I do have the standard C4 bezel coming, but also doubt that it can be properly machined to fit.
|
|
Forum: C4 ZR-1 General Postings
10-06-2021
|
|
Replies: 21
Views: 2,150
Antenna Bezel Replacement
It appears that the rubber antenna bezel for our ZR1's are no longer available, but I am curious as to if anyone has found an acceptable replacement. Mine is torn, and beyond trying to make one, I...
|
|
Forum: C4 ZR-1 Technical Postings
06-20-2014
|
|
Replies: 20
Views: 3,541
Re: Severe Stumble Intermittingly on my 90
Thanks for all the help.........turns out the issue was certainly the loose Positive battery connection as it has run perfectly ever since. Appreciate the help from the forum.
|
|
Forum: C4 ZR-1 Technical Postings
06-19-2014
|
|
Replies: 20
Views: 3,541
Re: Severe Stumble Intermittingly on my 90
So....am I supposed to jumper A & B, then ground K to get the codes? I only tried grounding pin K. The idea of getting the jumper from Gordon is a great idea. Will get it ordered. Thanks to all...
|
|
Forum: C4 ZR-1 Technical Postings
06-19-2014
|
|
Replies: 20
Views: 3,541
Re: Severe Stumble Intermittingly on my 90
Ok, so I tried to pull codes last night (wire to pin K, and grounded to frame). I got nothing....no 12 flashes, nothing. I have never tried to pull codes before, so could be my inexperience, but I...
|
|
Forum: C4 ZR-1 Technical Postings
06-18-2014
|
|
Replies: 20
Views: 3,541
Re: Severe Stumble Intermittingly on my 90
Both good points, and I have not tried running it without secondary key in off position. I actually am a little nervous to take it out for a drive after the amount of stumbling I saw before, but it...
|
|
Forum: C4 ZR-1 Technical Postings
06-18-2014
|
|
Replies: 20
Views: 3,541
|
|
Forum: C4 ZR-1 Technical Postings
06-18-2014
|
|
Replies: 20
Views: 3,541
Severe Stumble Intermittingly on my 90
My 90 is getting a severe stumble which feels as though I am getting no fuel every time it happens. Has never had an issue to this point. New injectors, new plugs about 1 year ago, and has run...
|
|
Forum: C4 ZR-1 General Postings
03-05-2007
|
|
Replies: 4
Views: 1,576
Re: Flashing SYS light???
Thanks guys. Will double check condition of the terminals........new battery last year, so hopefully okay. Yea, Wichita.......we call it Doo Dah! Have run into the other Blue ZR-1 at a couple...
|
|
Forum: C4 ZR-1 General Postings
03-05-2007
|
|
Replies: 4
Views: 1,576
Flashing SYS light???
I went to start my 90 the other day, and battery was too low........charged it and it is holding fine, but I have a flashing SYS light, which I assume is from the low battery charge. I figured once...
|
|
Forum: C4 ZR-1 General Postings
05-02-2006
|
|
Replies: 3
Views: 1,428
Re: Alternator going South???
Thanks guys. Good idea. I did change batteries about 2 months ago. Maybe my ground is not anchored well. Will check that and have a system check done and see where that takes me.
:handshak:
|
|
Forum: C4 ZR-1 General Postings
05-02-2006
|
|
Replies: 3
Views: 1,428
Alternator going South???
My 90 seems to have the voltage charge run lower than normal after the engine compartment gets up to temperature. It runs about midway on the gauge, which looks to me like about 12 volts. When the...
|
|
Forum: C4 ZR-1 General Postings
04-17-2006
|
|
Replies: 12
Views: 3,524
|
|
Forum: C4 ZR-1 General Postings
03-22-2006
|
|
Replies: 16
Views: 2,834
Re: MY NEW BNB SYSTEM INSTALLED
GREAT!!!!:handshak: Will Order these today. Looks similar to the "newstyle" clamps that were provided, but with the double bolt setup I am sure that will make a huge diff.
THANKS!!!
|
|
Forum: C4 ZR-1 General Postings
03-22-2006
|
|
Replies: 16
Views: 2,834
Re: MY NEW BNB SYSTEM INSTALLED
I should have been more specific, sorry. Not the tips actually that is the problem, it is the first joint in front of the mufflers that is clamped. The pipe actually slips and twists some which...
|
|
Forum: C4 ZR-1 General Postings
03-22-2006
|
|
Replies: 16
Views: 2,834
Re: MY NEW BNB SYSTEM INSTALLED
Hey Ray. Looks nice. I put mine on my 90 several months ago......group purchase at TByrne. I did resonator instead of X pipe hoping for less resonance, but got plenty at highway speed anyway. I...
|
|
Forum: C4 ZR-1 General Postings
10-05-2005
|
|
Replies: 148
Views: 57,746
|
|
Forum: C4 ZR-1 Parts For Sale / Wanted
06-23-2005
|
|
Replies: 5
Views: 2,694
|
|
Forum: C4 ZR-1 General Postings
02-16-2005
|
|
Replies: 29
Views: 6,550
1990 Red/Tan
Owned only for 1 year so...
1990 Red/Tan
Owned only for 1 year so far.......Still grinning!
Build #2410
Mileage: 20,175
Male Driver >45
Bone Stock, except Haibek perf. chip (Looking at exhaust though)
No other Corvettes
...
|
|
Forum: C4 ZR-1 General Postings
10-05-2004
|
|
Replies: 6
Views: 3,191
Thanks for the feedback. I ended up buying a...
Thanks for the feedback. I ended up buying a chip from Marc Haibeck, and it completely solved my problem. Man do I love this car! I went by a dealership owned by a friend of mine this past weekend...
|
|
Forum: C4 ZR-1 General Postings
08-26-2004
|
|
Replies: 6
Views: 3,191
Nuther Newbie: Got Questions already!
Hi all, just picked up my first ZR1: Red 1990/tan @ 18000 miles. What an AWESOME CAR! Already stoked, this thing is a blast. I do have one question that I have seen some posts on, but wonder if...
|
