|
|
|
11-16-2020
|
#1 | |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,061
|
Re: Cam Position Sensor Removal
Quote:
|
|
|
|
|
11-16-2020
|
#2 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
Re: Cam Position Sensor Removal
Is there a fix for this? JB weld? Silicone?
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp |
|
|
|
|
12-01-2020
|
#3 |
|
Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
Re: Cam Position Sensor Removal
Update:
Repaired the crack with JB weld for plastic. Used a Dremel to plow a small groove along the crack to give it more bite and roughed up with 180 sand paper. Use silicone around the o-ring seal as well. Did not install until everything had cured. So far no leak. Need more heat cycles to be sure but why not try.
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp Last edited by KJL; 12-01-2020 at 09:55 PM. |
|
|
|
|
12-01-2020
|
#4 | |
 
Join Date: May 2010
Location: Japan
Posts: 3,109
|
Re: Cam Position Sensor Removal
Quote:
Good job! That sounds like it will work well. Best wishes!! [emoji1303]🤙🏼 Sent from my iPhone using ZR-1 Net Registry
__________________
Craig "ZR-1 NO KA 'OI" "ZR-1 ICHIBAN" 1995 #228 Black/Black with Dunn Heads ZR-1 owner since September 2003 ZR-1 Net Registry Founding Member #0074 NCM Lifetime Member #2048 
|
|
|
|
|
 |
|
|
Hybrid Mode
