Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project - ZR-1 Net Registry Forums

Polo-1 · 02-11-2010

I used 2.00 Crower's. I'm not 100% sure if the outside dimension is smaller also, compared to the 2.100 rods.

Rod clearance was easy, just a little buff out on the girdle and the bottom of the block (liner).

I'm having Jeff run down to where me block/parts are. I hope to know tommrow. I was told it would be ready 2 weeks ago...........

02-11-2010	#1
Polo-1 Join Date: Sep 2005 Location: Washington Posts: 952	Re: Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project I used 2.00 Crower's. I'm not 100% sure if the outside dimension is smaller also, compared to the 2.100 rods. Rod clearance was easy, just a little buff out on the girdle and the bottom of the block (liner). I'm having Jeff run down to where me block/parts are. I hope to know tommrow. I was told it would be ready 2 weeks ago...........