![]() |
#11 |
![]() Join Date: Apr 2004
Location: Atlanta, GA
Posts: 2,170
|
![]()
Here are the codes: HVAC Diagnostic codes 0- System Faults (one of these will be set if your air conditioning controls have an LED flashing) 00=No Faults
01= Temp Door Motor Circuit Fault 02= Temp Door Motor Circuit Fault 03 = Ambient Sensor Open 04 = Ambient Sensor Short 05 = In-Vehicle Temp Sensor Open 06 = In-Vehicle Temp Sensor Short 07 = Solar Load Sensor Open 08 = Solar Load Sensor Short 09 = Low Freon Detected 10 = UART Failure 1- Temp Setting 60F to 90F 2- In-Car Temp Sensor 10 = HOT -130 = 230 = COLD 3- Outside Temp Sensor 10 = HOT -130 = 230 = COLD 4- Sun Load Sensor Max light Max Dark L98 38 183 LT5 115 -110 = 210 5- Ignition System Voltage 0 = 9 Volts -155 = 255 = 16 V 6- Engine Speed (RPM divided by 25) 7- Vehicle Speed 9- A/C System Mode 00 = OFF 01 = Re-Circulation 02 = A/C 03 = Bi-Level 04 = Heater 06 = Defrost 07 = Vent 10 = Manual Re-Circulation 10- Blower PWM 0 = 0 Volts 128 = 14 Volts 11- Program Number 00 = COLD -155 = 255 = HOT 12- Mix Number -155 = 255 = COLD 00 = COLD 16- Coolant Temperature In degrees C 17- Solar Correction 114 = Max light 128 = max dark 30- Stored Full Hot Value 0 to 50 31- Temp Door Travel Range 100 to 200 34- Temp Door Position Requested 00=Full HOT -153=253=Full COLD 35- Compressor On Time 0.1 second increments 36- Number Of Times Below Critical Time 37- Software Version Number
__________________
Steve 1990 Steel Blue/Black #2355 1990 Red/Red #1473 1991 Quasar /Black #118 Sold 1991 Turquoise/Black #766 Parted Out 1993 Yellow/White #179 Sold 1990 Black/Gray #1361 Headers/4:10s Sold |
![]() |
![]() |
|
|