ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

Reply
 
Thread Tools Display Modes
Old 07-25-2009   #1
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,686
Default Re: Rough Idle/Hesitation/Backfire

Quote:
Originally Posted by tomtom72 View Post
Gary, I have a 90 and I know for sure that my TPS is adjustable...to what degree I don't know, but the screws that hold it in place are in slotted holes, therefore I conclude it's adjustable.

You may want to look closely at those screws as you maybe able to make an adjustment. If you say that the needle on the VOM moves thru it's sweep at a smooth progression then maybe an adjustment is in order.

Just a fwiw, try it, in the end you can always go spend the money if the adjustment don't work.


Tom
Gary

As TT has said, loosen the TWO bolts on the side of the TPS and adjust with IGN ON so the DVM reads about .54v. Then tighten bolts
and check WOT TPS signal. Should be at 4.5v or higher. If not,
swap in new TPS.
XfireZ51 is offline   Reply With Quote
Old 07-25-2009   #2
secondchance
 
Join Date: Aug 2006
Location: McLean, VA
Posts: 3,730
Default Re: Rough Idle/Hesitation/Backfire

When you say back fire, do you send detonation in the plenum or hear it at the tail pipe?

I never had this situation with fuel injected cars but way back when cars had carburators, cracked ign. wire would make gas vapor explode into the air filter housing.

If it is coming through the tailpipe, its coming from uncombusted fuel detonating when it his catalytic converter.

I very much doubt TPS, even if off a little, would do this.

Lastly, I struggled with a similar symptom a few years ago. In my case it was hairline crack on one plug (very difficult to see). Cracked plug wire will behave in similar manner.
secondchance is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:01 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025