![]() |
#1 |
![]() Join Date: Nov 2016
Location: New Brunswick
Posts: 951
|
![]()
Hi Folks.
Before swapping alternators again, I'm trying to figure out what might be causing them to fail. The best suggestions I've gotten so far is bad grounds. Any thoughts on what ground points I should be looking at to check this? Any known culprits? Thanks!
__________________
1990 ZR-1 # 996 "All Corvettes are red. The rest are mistakes." - John Heinricy |
![]() |
![]() |
![]() |
#2 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,697
|
![]()
Have u looked at the harness connector? The plastic gets brittle and cracks which then leads to grounding on the alternator shell. I replaced on alternator that blew out before I discovered the connector allowing +/ - poles to short circuit.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
![]() |
![]() |
![]() |
#3 |
![]() Join Date: Nov 2016
Location: New Brunswick
Posts: 951
|
![]()
Great idea. I?ll have a look.
__________________
1990 ZR-1 # 996 "All Corvettes are red. The rest are mistakes." - John Heinricy |
![]() |
![]() |
![]() |
|
|