no spark

[JG95ZR1]

Check the connecter of the crank position sensor on the right side of the engine or do an ohm test at the connector that goes to the DIS.


Sent from my iPhone using ZR-1 Net Registry

[XfireZ51]

I was going to also suggest crank sensor. Without any signal, there?s no spark. Won?t set a code until ECM takes over running motor.

[DRM500RUBYZR-1]

Originally Posted by JG95ZR1

Check the connecter of the crank position sensor on the right side of the engine or do an ohm test at the connector that goes to the DIS.


Sent from my iPhone using ZR-1 Net Registry

AND the wire itself.
Perhaps it was the daily special for the the hungry local rodents.
Keep us updated.

Marty