|
07-11-2021
|
#1 |
|
Join Date: May 2020
Location: Fort Lauderdale
Posts: 6
|
My 93 sputters and dies NEED HELP
Hi,
I have a n issue with my 93 ZR1. A few weeks ago my ZR-1 started to die when she was cold and I had to keep her on RPMS to keep her running. Now the issue is worse and she runs rougher and dies directly after starting. Has anyone had similar problems and may knows where I should start searching for the problem? Thanks you all! |
|
|
|
07-11-2021
|
#2 |
 
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
|
Re: My 93 sputters and dies NEED HELP
Test Fuel Pump Pressure
Search "Solutions" at the top of the page where you posted this thread
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
|
|
|
|
07-12-2021
|
#3 |
 
Join Date: Jan 2009
Location: New jersey
Posts: 156
|
Re: My 93 sputters and dies NEED HELP
what jerry said above
and possibly check out the idle control motor.. |
|
|
|
|
07-12-2021
|
#4 |
 
Join Date: Aug 2012
Location: Ellicott City, MD
Posts: 1,714
|
Re: My 93 sputters and dies NEED HELP
Check to see if one of the rubber hoses disconnected from one of the fuel pumps. Pull the fuel pump assembly from the tank and check, takes less than 30 minutes. That was the problem with mine. A new stainless steel clamp fixed the problem.
__________________
Charlie __________ Dredgeguy WAZOO Member 1992 Bright Red/Black ZR1 #246 Dana 4:10 gears Polished LT5 by Haibeck Polished Fikse FM5's with Michelin Pilot Sport 2 Stainless Works headers and cats with Corsa |
|
|
|
|
07-12-2021
|
#5 |
Join Date: Sep 2017
Location: Twin Cities, MN
Posts: 125
|
Re: My 93 sputters and dies NEED HELP
My situation was this. Car would start up fine, run great for two minutes, and then stumble. It was the oxygen sensors.
__________________
1967 Corvette convertible, L79, 4 speed, red / black / white top 1994 Corvette ZR-1, white / black NCRS North Central Chapter Judging Chairman |
|
|
|
|
07-12-2021
|
#6 |
|
Join Date: May 2020
Location: Fort Lauderdale
Posts: 6
|
Re: My 93 sputters and dies NEED HELP
Hi Guys! Thanks for your input.
I found the Problem. It was the vaccum hose that was detached from the MAP Sensor. |
|
|
|
|
07-12-2021
|
#7 | |
|
Join Date: Nov 2016
Location: New Brunswick
Posts: 961
|
Re: My 93 sputters and dies NEED HELP
Quote:
 Congrats.
__________________
1990 ZR-1 # 996 "All Corvettes are red. The rest are mistakes." - John Heinricy |
|
|
|
|
|
07-13-2021
|
#8 |
|
Join Date: Jan 2009
Location: New jersey
Posts: 156
|
Re: My 93 sputters and dies NEED HELP
watch out for backfires, they can pop that hose off...
FYI |
|
|
|
|
07-13-2021
|
#9 | |
|
Join Date: May 2020
Location: Fort Lauderdale
Posts: 6
|
Re: My 93 sputters and dies NEED HELP
Quote:
|
|
|
|
|
|
07-13-2021
|
#10 |
|
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
|
Re: My 93 sputters and dies NEED HELP
Cause: Releasing ignition key too soon from start position.
Cure: Hold key in start position just a second longer Sent from my iPhone using ZR-1 Net Registry
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
|
|
|
 |
|
|
Linear Mode
