![]() |
#1 |
![]() Join Date: Jul 2005
Location: Lees Summit, MO
Posts: 102
|
![]()
I recently had the windshield in my 91 replaced by Safelite. The windshield looks great and they did a very nice job on the install. However, there was a terrible wind noise where the passenger window meets the rubber molding. Safelite said the molding was defective and replaced it. Now there is wind noise where the top meets the molding above the windshield. Are there differences in rubber molding suppliers? Would I be better off procuring the molding myself instead of letting Safelite provide it? It just doesn't seem that getting a tight seal should be this difficult.
|
![]() |
![]() |
![]() |
#2 | |
![]() Join Date: Nov 2007
Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri
Posts: 6,466
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#3 | |
![]() Join Date: Nov 2016
Location: Southlake, TX
Posts: 599
|
![]() Quote:
__________________
Bill Schroeder Texas Proud! 1991 Corvette ZR1 #1388 2015 Challenger Scat Pack Shaker [SIGPIC][/SIGPIC] |
|
![]() |
![]() |
![]() |
#4 | |
![]() ![]() Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,813
|
![]() Quote:
![]() Replacing the Windshield and Wiper Motor
__________________
Clickable links ![]() On Iphone Touchable Links -Solutions- LT5 Modifications/Rebuild Tricks Low Mileage ZR-1 Restoration 1990 Corvette (L98) Modifications LT5 Eliminated Systems LT5 Added Systems LT5/ZR-1 Fluids 1995 LT5 SPECIFIC TOP END REBUILD TRICKS Last edited by Dynomite; 12-03-2016 at 08:07 PM. |
|
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Jul 2005
Location: Lees Summit, MO
Posts: 102
|
![]()
Thanks for the advice. That will be my next step.
|
![]() |
![]() |
![]() |
#6 |
![]() Join Date: May 2011
Location: Sydney, Australia
Posts: 2,466
|
![]()
corvette-rubber.com
|
![]() |
![]() |
![]() |
|
|