Z06 Wheels - About to pull trigger, need a little advice.

[BigIke]

I'my about to buy some Speedline Z06 wheels with 345/19's and 275/18's. GOOD tread and I need another set of rear tires, I think for 800$ these will fit the bill...

I've seen 20mm adapters on EBay with spline style lug nuts for 60$ Is that the correct width spacer?

Any links to the 'perfect' spacer?

[XfireZ51]

Originally Posted by BigIke

I'my about to buy some Speedline Z06 wheels with 345/19's and 275/18's. GOOD tread and I need another set of rear tires, I think for 800$ these will fit the bill...

I've seen 20mm adapters on EBay with spline style lug nuts for 60$ Is that the correct width spacer?

Any links to the 'perfect' spacer?

I'm using 18mm. You will need longer wheel studs for the rear. What are the tires? You will also need to shave the bolt head for the top "dog bone" in the rear.

[XfireZ51]

Check out this post from Jagdpanzer. That top bolt interferes w side wall.
I found that the DRM BRACKETS really help with control wheel travel and so the rear inner fender wells did not need trimming. There are other subtle differences between my install and Phil's.

http://zr1.net/forum/showpost.php?p=234707&postcount=13

[XfireZ51]

You'll want both hub and wheel centric spacers.

http://www.wheeladapter.com/wheel_spacers.php