07-31-2013 | #1 |
Join Date: Nov 2006
Location: Las Vegas, Nevada
Posts: 137
|
Secondary Port Control Solenoid Resistance
I have a digital Fuke 93 and out of curiosity I wanted to compare my replacement Solenoid with the old one which is what my Tech 1 seemed to be telling me was my problem.
I compared the Ohms between pins on both and have two very different readings? Does anybody have a new one that they can check or a known good one?? or does anybody have it written down the resistance of a good one?? My replacement is also used but pulled to upgrade to a LT5.1 and eliminate this vacuum issues. West Yellowstone , West Yellowstone, I can do it.
__________________
[SIGPIC][/SIGPIC] |
07-31-2013 | #2 |
Join Date: Nov 2006
Location: Las Vegas, Nevada
Posts: 137
|
Re: Secondary Port Control Solenoid Resistance
Thanks Mark Haibeck for the resistance reading of 97 Ohms on a new one. Target must have been 100 Ohms.
The one I'm taking out would seem it wasn't toast, as it wasn't going to infinity which is what I was expecting, but reading 50.8 Ohms. West Yellowstone , West Yellowstone.
__________________
[SIGPIC][/SIGPIC] |
07-31-2013 | #3 |
Join Date: Nov 2006
Location: Las Vegas, Nevada
Posts: 137
|
Re: Secondary Port Control Solenoid Resistance
Oh, the other used replacement was reading 93.5 Ohms. Yes that is the one going back in now.
Thanks again Marc.
__________________
[SIGPIC][/SIGPIC] |
08-01-2013 | #4 |
Join Date: Nov 2006
Location: Las Vegas, Nevada
Posts: 137
|
Re: Secondary Port Control Solenoid Resistance
Secondaries are working perfectly.
Eveything went back together just fine. So nice to have the Power of the ZR-1 BEAST BACK!! Thanks everyone.
__________________
[SIGPIC][/SIGPIC] |
|
|