Extrude Honing? - Page 3 - ZR-1 Net Registry Forums

SillyB · 02-04-2011

Quote:

Originally Posted by Paul Workman

There's "better" and there's "best".

I would agree 100% here. I had my stuff ported years ago, before I really started to read this forum. I was trying to replicate the DRM 500/415 so I followed their process, which is "better" than stock. After talking to Marc Haibeck about his hand porting a few years later I realized that I had left some ponies on the table, and that his work would have been "best".

Oh well, no use crying over spend $. Either way it helps keep you in front of those C5s!

Paul Workman · 02-04-2011

[QUOTE=SillyB;107039Either way it helps keep you in front of those C5s!

[/QUOTE]

AND C6s

02-04-2011	#22
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,493	Re: Extrude Honing? [QUOTE=SillyB;107039Either way it helps keep you in front of those C5s![/QUOTE] AND C6s __________________ Good carz, good food, good friendz = the best of timez! 90 #1202 "FBI" top end ported & relieved Cam timing by "Pete the Greek" Sans secondaries Chip & dyno tuning by Haibeck Automotive SW headers, X-pipe, MF muffs Former Secretary, ZR-1 Net Registry