Can the rear hubs be rebuilt? - ZR-1 Net Registry Forums

batchman · 04-06-2012

No press needed unless you have to switch aftermarket studs over. You do need a stout torque wrench (164 ft/lb IIRC) and it's a big honking Torx on the inside. You can do it without dropping the arms but it's a little close - think long extensions and wobble. Sounds like you'll be dropping it all anyway though.

Watch out for the thin flat washer deal when you break the hub nut, pay attention to which way it's in there - it's slightly dished.

HTH,
- Jeff

04-06-2012	#1
batchman Join Date: Jun 2009 Location: I live at Devens, one run at a time Posts: 454	replacing rear hubs No press needed unless you have to switch aftermarket studs over. You do need a stout torque wrench (164 ft/lb IIRC) and it's a big honking Torx on the inside. You can do it without dropping the arms but it's a little close - think long extensions and wobble. Sounds like you'll be dropping it all anyway though. Watch out for the thin flat washer deal when you break the hub nut, pay attention to which way it's in there - it's slightly dished. HTH, - Jeff

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode