Quote:
Originally Posted by XfireZ51
I put just a tiny bit of electrical tape on the 1/4? extension before sliding the socket on the end. That really snugs the socket onto the either the socket driver or 1/4? drive socket wrench.
|
Yes! Me too!
Also, I put that connector back on
BEFORE I bolt the plenum back down. That little bit of extra room allows me to gently maneuver and position that connector in place: actually
feel the pins sliding into place before the connector bottoms out. Then the set screw/bolt only secures the connector from coming off:
that way it never is used to wrench the connector over the pins (is when pins get folded/bent).