ZR-1 Net Registry Forums - View Single Post

Flyman 27 · 11-03-2018

I would use a 90 degree "pick" tool to slip in between the hose & steel tube, then work it around. You will want to install new fuel hose and clamps. I got German clamps from Amazon, didn't want to install Chinese clamps.
Mark H told me that he commonly removes the cover to the sending unit & cleans off the resister coil with a scotch brite pad. This usually works for him.
The R&R is an easy DIY job, just get a new gasket first like recommended above.

11-03-2018	#4
Flyman 27 Join Date: Apr 2017 Location: Wayne Illinois Posts: 404	Re: Sender unit safe to pull? I would use a 90 degree "pick" tool to slip in between the hose & steel tube, then work it around. You will want to install new fuel hose and clamps. I got German clamps from Amazon, didn't want to install Chinese clamps. Mark H told me that he commonly removes the cover to the sending unit & cleans off the resister coil with a scotch brite pad. This usually works for him. The R&R is an easy DIY job, just get a new gasket first like recommended above. __________________ [SIGPIC][/SIGPIC] 91-#1935 Black/black & gray, Haibeck 500 Cams by Pete