ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > Search Forums

Showing results 1 to 22 of 22
Search took 0.00 seconds.
Search: Posts Made By: pig_iron
Forum: C4 ZR-1 Technical Postings 07-04-2009
Replies: 17
Views: 6,455
Posted By pig_iron
Re: NO START

YES. There was an aftermarket alarm installed at one point. It was disabled before I bought it. I have encountered dead end wires wherever I look from the alarm system.

I drove it with the cruise...
Forum: C4 ZR-1 Technical Postings 07-04-2009
Replies: 17
Views: 6,455
Posted By pig_iron
Re: NO START

Here is my clutch switch. There is the connector for the cruise control. But I see nowhere where there could possibly be a purple wire attached to it. I disassembled the switch, cleaned all contacts,...
Forum: C4 ZR-1 Technical Postings 07-04-2009
Replies: 17
Views: 6,455
Posted By pig_iron
Re: NO START

It is definitely the clutch switch that is unplugged and I suspect that it has already been modified because there is no purple wire going anywhere near the clutch... Just a little plug in to the...
Forum: C4 ZR-1 Technical Postings 07-03-2009
Replies: 17
Views: 6,455
Posted By pig_iron
Re: NO START

Uhhhh.... Is it possible for the car to start when the clutch switch is completely unplugged? The plug-in for the switch has been disconnected and the car starts right up... I just don't get this...
Forum: C4 ZR-1 Technical Postings 07-03-2009
Replies: 17
Views: 6,455
Posted By pig_iron
Re: NO START

How do I "jumper around it"? I've found it but I need more detail on what you mean by "jumping".
Forum: C4 ZR-1 Technical Postings 03-07-2009
Replies: 7
Views: 1,892
Posted By pig_iron
Re: Power seats & door locks not working...

Yep. The problem was the main feed under the center console to the power seats. I took apart the side of the console to find a melted mess of electrical tape and a burn mark on the insulation between...
Forum: C4 ZR-1 Technical Postings 03-07-2009
Replies: 7
Views: 1,892
Posted By pig_iron
Re: Power seats & door locks not working...

Both seats are completely out. Bolster buttons and switches are ok and the seats work properly through an outside battery source (out of the car). Even w/ no seats in the car, nothing hooked up, that...
Forum: C4 ZR-1 Technical Postings 03-06-2009
Replies: 7
Views: 1,892
Posted By pig_iron
Power seats & door locks not working...

Well the first startup of the spring gave me several surprises. One was that my 2 year old Optima battery was so dead I had to take it into AutoZone to have them test it. It registered nearly zero...
Forum: C4 ZR-1 Technical Postings 01-04-2009
Replies: 4
Views: 2,083
Posted By pig_iron
Wheel lug key lost...

I seem to have lost the wheel lug key for my 91 ZR1. In the owner's manual, it states that if it is lost, a replacement key can be ordered but I need the serial number from the "lug key kit", which I...
Forum: C4 ZR-1 Technical Postings 08-07-2007
Replies: 7
Views: 2,430
Posted By pig_iron
Re: Hole in fuel line

Damn... If they're both discontinued is there a way to repair them?

Thanks for checking man.
Forum: C4 ZR-1 Technical Postings 08-07-2007
Replies: 7
Views: 2,430
Posted By pig_iron
Re: Hole in fuel line

Okay I didn't realize there were 2 lines there. The one that's leaking is the inside one. So whichever that one is. It has finally stopped after about 10 hrs, and I am assuming my tank is empty...
Forum: C4 ZR-1 Technical Postings 08-07-2007
Replies: 7
Views: 2,430
Posted By pig_iron
Re: Hole in fuel line

1991. I'm guessing it's the feed line because it's been leaking for the last 6 hours..
It's the line right below the passenger door.
Forum: C4 ZR-1 Technical Postings 08-06-2007
Replies: 7
Views: 2,430
Posted By pig_iron
Hole in fuel line

To make a long story short, my dumbass accidentally drilled a small hole into the fuel line on the passenger side just below the door. Is this repairable, or am I going to have to purchase a whole...
Forum: C4 ZR-1 Technical Postings 07-10-2007
Replies: 12
Views: 8,734
Posted By pig_iron
Forum: C4 ZR-1 Technical Postings 07-09-2007
Replies: 12
Views: 8,734
Posted By pig_iron
Re-wiring the power key

Sorry if this topic has been covered but I have combed the threads and not found anything on it yet. I have the center console apart for stereo reasons and was wondering if anyone knew how to wire...
Forum: C4 ZR-1 Technical Postings 09-09-2005
Replies: 1
Views: 1,438
Posted By pig_iron
choppy accelleration...

What started out as a little hesitation after shifting gears has become a full onslaught of choppy, jerky accellerating. Stepping on the gas displays a very rough ride and I can even feel a little...
Forum: C4 ZR-1 Technical Postings 06-06-2005
Replies: 5
Views: 3,687
Posted By pig_iron
The map sensor connection it was. Thanks.

The map sensor connection it was. Thanks.
Forum: C4 ZR-1 Technical Postings 05-30-2005
Replies: 5
Views: 3,687
Posted By pig_iron
At the risk of sounding like a complete dumbass...

At the risk of sounding like a complete dumbass I'm going to have to ask where the map sensor connection is.
Forum: C4 ZR-1 Technical Postings 05-29-2005
Replies: 5
Views: 3,687
Posted By pig_iron
Running rough...

Lately the Z has been hesitating a tad after shifting gears. Today I went to start it and it sounded like a cat was caught in the engine. It ran a few miles to the storage unit, where it proceeded to...
Forum: C4 ZR-1 General Postings 02-02-2005
Replies: 12
Views: 3,163
Posted By pig_iron
The lowering bolt is very easy to do yourself. ...

The lowering bolt is very easy to do yourself. Just jack the car up and put a jack stand under the spring near the bolt and lower the car slightly to take the pressure of the bolt, then un-screw it...
Forum: C4 ZR-1 General Postings 02-01-2005
Replies: 12
Views: 3,163
Posted By pig_iron
Thanx for the info. I did decide to go with 18x12...

Thanx for the info. I did decide to go with 18x12 rears from Budnik. I found the set of lowering bolts from Mid America, and they're relatively cheap. Can the spring bolt replacement be done by any...
Forum: C4 ZR-1 General Postings 01-24-2005
Replies: 12
Views: 3,163
Posted By pig_iron
a few questions about wheels and springs...

Howdy ZR1 enthusiasts. I have a few questions about the car that I can't seem to get answered anywhere else. Firstly, I have a 91 Z and I want to upgrade to 18 or possibly 20 inch wheels. What would...
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -4. The time now is 07:49 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025