Clutch time
 

What are the opinions of the lords of Z as to clutch preference?

Stock,
Centerforce,
Spec,
Beck?
other?

The throwout bearing will need to be changed in mine, and I'm guessing that I will just change the clutch while I'm at it.

Oh, and add an aluminum flywheel and put the hurst shifter in at the same time.

Re: Clutch time
 

id get ahold of bill b the zfdoc and get what ever he recommends

Re: Clutch time
 

http://www.zr1netregistry.com/forum/...9&postcount=12

http://www.zr1netregistry.com/forum/...61&postcount=7

http://www.carolinaclutch.com/images/Header.gif

I AM A VERY HAPPY CUSTOMER OF CC NOW!!!

Re: Clutch time
 

You don't need anything wild or exotic. There are guys with stroker motors running around on the stock set up.

You should still be able to get the stock LUK pressure plate assembly from either Bill B www.zfdoc.com or go and talk to Tom @ Carolina Clutch.

Re: Clutch time
 

I talked to Bill a day ago. He recommended going with Carolina Clutch.

Now all I need is a lift to get under the car with......

KT

Re: Clutch time
 

No problem, Ken. I used jack stands (up pretty high) and
removed my trans when I had to get a new one from Bill B.
Warning- the trans is surprisingly heavy. A Bit*h to lower,
and a Bit*h to maneuver to re-install. And be careful with
the pilot bearing/rear engine seal.

Re: Clutch time
 

hi. who is bill is he a tranny guy mine acts funny seomtimes the pedal feels funny ti only comes up a few inches. bradslt5 you are in california too i see.

Re: Clutch time
 

Bill Boudreau knows and works on ZF trans/clutches, etc.
and is in AZ.
His website is:

http://www.zfdoc.com/

Re: Clutch time
 

ya where are you located? is yucca valley down by palm springs? are you a new zr1 owner too ?

Re: Clutch time
 

who is billb is he a real doctr. haha
yah im by 29 palms too

tf95zr1 i didnt see that link it looks like i have a hydraulic problem thanks. hope my transission isnt hurt