F/S throttle body good canidate for a 63MM

[phrogs]

This throttle body came with a motor I bought years ago and it has been on the shelf for a while.
It had a broken screw on the top for the coolant cover, and whoever worked on this not only drilled into the air chamber but broke the tap off in the throttle body.
I removed the broken drill bit and then had a old friend that welded inside of the 2 screw holes to fill the damaged holes 2 were drilled out he then started to machine these areas but I had him stop where it is as you see it so if someone wanted a coolant bypass and a 63MM throttle body this is a perfect canidate.
when you send it off to be machined for the 63mm bore any machinist could finish off the upper side I would have but I do not have a mill at my disposal anymore.
I know I can make this a functioning TB so it is not trash and I will not give it away.
Ill offer this piece of aluminum for $175 as you see it.

http://i150.photobucket.com/albums/s103/zr1salvage/parts/IMG_1160.jpg
http://i150.photobucket.com/albums/s103/zr1salvage/parts/IMG_1162.jpg
http://i150.photobucket.com/albums/s103/zr1salvage/parts/IMG_1163.jpg
http://i150.photobucket.com/albums/s103/zr1salvage/parts/IMG_1164.jpg

[A1990]

Johnny, do you still have this?

[phrogs]

I do still have it sent you a PM as well