differential case issue, and Coil-over shock removel.?

[HADI-ZR1]

Is there any way to weld the case where it break? see [pic]. or i have to change it all?

http://i128.photobucket.com/albums/p183/hadi-zr1/DSC00548.jpg


How to remove the Black Sleeve over shocks? by press or ...?

http://i128.photobucket.com/albums/p183/hadi-zr1/DSC00546.jpg

[Pete]

Hadi the rear end is very fixable.

The black sleeve should slide off the shock upwards might need rubber mallet to knock it loose.

Pete

[HADI-ZR1]

Pete ,
so what Procedure and steps to repair this broken piece?!?

I alreday removed the shock from the black sleeve. I had this "Coil-over shock" from exotic muscle long time ago, i try to lower the rear , but no chance, cuz the spring height is 26 cm,and i screw it to the end! the gap between tire and fender still 2 inch!!:mad:
so by changing the spring height with 22-23 cm , will the rear lower more??:neutral:

Pete , about the front strip 1991 bumper. I saw :
The front strip molding is fixed into the front bumper (1991-95), its not separated from the front bumper, same for the rear!

[Pete]

Is that Dana 44?
A piece of round aluminum stock weld and drill.
I would take it all apart and bolt each half on a steal plate.
Did somebody tell you it can't be repaired or it's junk?
I'll take that junk.

Pete

[HADI-ZR1]

its not junk , its my ZR Dana 44 . :p
no one told me it cant be repair, Pete.