replacement shocks

[ZR1CK]

A shout out here, looking for info on what needs to be done with the Selective Ride Control unit when installing non SRC shocks. Any and all info is appreciated and welcome.
Thanks
Rick

[G8nightman]

You can remove the actuators and the warning bulb on the DIC


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)

[ZR1CK]

Okay...that's it? I read somewhere in some forum or whatever, that the Selective Ride Control module needed to be disconnected. Any thoughts on that? And, thanks for your reply.
:thumbsup:

[secondchance]

Okay...that's it? I read somewhere in some forum or whatever, that the Selective Ride Control module needed to be disconnected. Any thoughts on that? And, thanks for your reply.
:thumbsup:

I don't think disconnecting the SRC module is necessary. If it ever gets to a point where I cannot keep SRC serviced, I would leave the actuator ends hanging and remove the bulb behind service SRC warning light.

[ZR1CK]

Okay, thanks. I did remove the actuators from the front so far, didn't want 'em loose and just hangin' around. Planning on heading out to the garage tomorrow and finishing up. And will unplug the indicator light. Again, appreciate the info.
Rick J
:cheers: