RH oem harness routing

[tpepmeie]

This is a long shot, but does anybody have a good photo(s) of the factory lower wiring harness routing. Ideally on an original car or close to it. Doing a resto and struggling to route the crank position, oil level sensor and passenger O2 wiring.

It?s a 93, so the cats are removed. Which gives me some access. I just don?t have any original photos.

Thanks.


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)

[Jagdpanzer]

The harness run down behind the right cylinder head. The O2 wiring splits off as seen here
12208

12211

The remaining harness runs forward connecting to the oil level and crank sensors.

12209

12210


Sent from my iPhone using ZR-1 Net Registry (http://r.tapatalk.com/byo?rid=90383)

[dredgeguy]

That gentlemen is a better than new engine and clean engine bay!

[A26B]

Yes, that's what I was thinking. You want to come and spend the summer with me Phil? Shop is air conditioned & plenty for you to do if you were so inclined.

[XfireZ51]

Seriously Phil. Does that motor even have any fluids in it? 🤣🤣😉

[tpepmeie]

Phil for the win. Thanks, man.

[Jagdpanzer]

Seriously Phil. Does that motor even have any fluids in it? 🤣🤣😉

Full credit due to Jerry's excellent gaskets and sealants.