Cam Position Sensor

[Locobob]

Anyone know where I can get a new cam position sensor?

[KPW]

http://www.rockauto.com/en/moreinfo.php?pk=40311&cc=1041297&jsn=601

$182

I was looking through the members ZR-1 parts list catalog ~680 page PDF, trying to confirm that this is OK, but I haven't found it yet.

[Z51JEFF]

I think Standard is the brand I got a few years ago.

[Locobob]

Well thanks for the link but I'm still SOL... looked at it earlier and it was in stock, went to order tonight and now it's showing out of stock :(

[Locobob]

Found one, thanks for the tip!

[Dynomite]

Found one, thanks for the tip!

Where did you find the Camshaft Position Sensor? Does it come with "O" Ring?
I know Jerry has the Camshaft Position Sensor "O" Ring.

[Locobob]

Found one on Amazon, hopefully it comes with the oring, just kind of assumed it does.

[Dynomite]

I prolly missed it.......but how you figure out your camshaft position sensor was bad?

Could be connection, wires, DIS.

After tracking down Blown INJ1 fuse issues for a week and after removing plenum five times ........I am convinced anything is possible [emoji3]

What I did is put Ohm meter on down side of INJ1 fuse and starting at 1,200 Ohms watched the Ohm meter as I removed the Plenum. Especially as I disconnected various connectors or wiggled various wire looms/wires. Found the 14pin DIS connector movement caused Ohm meter to go to near zero Ohms ;)

ah ha.........but still do not know exactly why.......I know where problem was but not What problem was lol lol lol

Sent from my iPhone using ZR-1 Net Registry (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=90383)

[Z51JEFF]

The sensor I got wouldn't allow the small stock sensor guard to fit so I left it off. To get the guard back on the car you will need to modify it,trim it a bit.

[Locobob]

I prolly missed it.......but how you figure out your camshaft position sensor was bad?

Could be connection, wires, DIS.

After tracking down Blown INJ1 fuse issues for a week and after removing plenum five times ........I am convinced anything is possible [emoji3]

What I did is put Ohm meter on down side of INJ1 fuse and starting at 1,200 Ohms watched the Ohm meter as I removed the Plenum. Especially as I disconnected various connectors or wiggled various wire looms/wires. Found the 14pin DIS connector movement caused Ohm meter to go to near zero Ohms ;)

ah ha.........but still do not know exactly why.......I know where problem was but not What problem was lol lol lol

Sent from my iPhone using ZR-1 Net Registry (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=90383)

I got a code 31 and went through the FSM troubleshooting chart.

[Locobob]

The sensor I got wouldn't allow the small stock sensor guard to fit so I left it off. To get the guard back on the car you will need to modify it,trim it a bit.

Good to know, I'll check it before mounting