Recognize this hose??.....

[ZONER 95]

Found this hose floating around loose in the engine bay of my 95.....its only about 6" long and has a flared end like it would just pop into something......I've looked all over for its home without any luck.....any ideas?......found near windshield wash fluid fill....

http://i24.photobucket.com/albums/c17/58powerwagon/Jointer010.jpg

[A26B]

condensate drain tube from A/C evap. look for a hole in the bottom of the housing, near the firewall.

[GOLDCYLON]

Concur. 100%

[ZONER 95]

Thanks guys...will go check it out

[VetteVet]

The flared end should pop into a hole in the lower front of the blower motor housing. The other end should then line up with a nipple on the evaporator case.

[ZONER 95]

Thanks....figured it out and she's back on.....Kevin

[Corvettes White]

I do not think so. I believe this is the Blower Motor Cooling Hose. It conducts fresh air from the plenum to the motor windings to cool the them. Condensate drain is at the bottom of the case, This is on the side.

George

[VetteMed]

I do not think so. I believe this is the Blower Motor Cooling Hose. It conducts fresh air from the plenum to the motor windings to cool the them. Condensate drain is at the bottom of the case, This is on the side.

George

I agree, George.

[ZONER 95]

The flared end should pop into a hole in the lower front of the blower motor housing. The other end should then line up with a nipple on the evaporator case.


This is where it fit......thanks

[Corbusa]

Is there some way to make sure it doesnt fall off again ? I'd hate to lose it while driving.

[ZONER 95]

Now that its back on it seems pretty snug.....I don't think it will fall off but will be checking it periodiclly.