XfireZ51
08-13-2011, 02:59 PM
This is a Raptor I am using but the Harlan is nearly identical. It uses the diag harness connector for switched power and tach feed. Then a simple extension to ground somewhere on the block. I use the MAP sensor mounting bolt. Plug and Play.
http://i187.photobucket.com/albums/x198/Z51Xfire/shiftlte3.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/Shiftlte2.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/Shiftlte1.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/PICT0066.jpg
Easy routing through door gasket and then tucked between pillar and IP pad. "A" pillar location also makes light easily accessible for changing shift points.
http://i187.photobucket.com/albums/x198/Z51Xfire/shiftlte3.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/Shiftlte2.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/Shiftlte1.jpg
http://i187.photobucket.com/albums/x198/Z51Xfire/PICT0066.jpg
Easy routing through door gasket and then tucked between pillar and IP pad. "A" pillar location also makes light easily accessible for changing shift points.