04-25-2010 | #1 |
Join Date: Nov 2007
Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri
Posts: 6,493
|
"New" seats!
I installed my "new" 95 (standard) seats yesterday: no more left leg falling asleep after 2-3 hours!
These are the seats identical to the ones in my LT1 95 car which I found I could sit in comfortably - my bladder being the limiting factor and not my butt! My interior is red/black, so the black seats blend right in, methinks. Later, mebby next winter, I'll go the route =Jeff= did and do the seat cushion and the center section of the seat back in RED. New carpeting is definitely on the list for next winter, if not sooner. Out goes the "Flame Red" and in goes "Torch Red"...perhaps?? (Something more closely matching the exterior and door trim panels, would be my preference.) For those who have have never done it, few things are easier to do than swap seats, I found. I expected a hassle (as usual). But,-
The seats are still moved back and forth by the console switches, and the whole process took about 1/2 hour. HTH, P.
__________________
Good carz, good food, good friendz = the best of timez! 90 #1202 "FBI" top end ported & relieved Cam timing by "Pete the Greek" Sans secondaries Chip & dyno tuning by Haibeck Automotive SW headers, X-pipe, MF muffs Former Secretary, ZR-1 Net Registry |
04-25-2010 | #2 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,698
|
Re: "New" seats!
Now all you need is a motor to complete the transformation.
|
04-25-2010 | #3 |
Join Date: Nov 2007
Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri
Posts: 6,493
|
Re: "New" seats!
Oh...details, details...
The paint part went well, methinks. Still holding out hope to have it together in a couple weeks (in time for BG). P.
__________________
Good carz, good food, good friendz = the best of timez! 90 #1202 "FBI" top end ported & relieved Cam timing by "Pete the Greek" Sans secondaries Chip & dyno tuning by Haibeck Automotive SW headers, X-pipe, MF muffs Former Secretary, ZR-1 Net Registry Last edited by Paul Workman; 04-25-2010 at 01:20 PM. |
04-25-2010 | #4 |
Join Date: Mar 2004
Location: Found Member
Posts: 4,346
|
Re: "New" seats!
Very nice up grade.
|
04-26-2010 | #5 |
Join Date: Dec 2004
Location: Jacksonville, FL USA
Posts: 4,645
|
Re: "New" seats!
okay I know this is kind of dumb, but what happens to all the controls that the 90 sport seats had built into each thigh bolster? They become non-functioning with the swap, right?
TIA Tom
__________________
1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member |
04-26-2010 | #6 |
Join Date: Jul 2007
Location: Bartlett, IL
Posts: 7,155
|
Re: "New" seats!
right because those seats Paul swapped to are Standard not Sport..
__________________
1990 Corvette ZR-1 #1051 Watson Headers (2" Primary) - Flowmaster Cats - Borla Catback Late Model IH - Plenum Coilovers - 4.10s Custom Interior NCM Lifetime Member #978 |
|
|