|
09-23-2017
|
#1 |
 
Join Date: Jul 2015
Location: Ypsilanti, MI
Posts: 116
|
Lumbar Control Bezel Hardware
Anyone know what sort of fastener is used to put the Lumbar Control Bezels (link below) on my '91? Previous owner put in new seats/foam, but never installed the controls in the seat, so I don't even have one to compare to.
https://www.vette2vette.com/?q=produ...ch-pod-bezel-6 Thanks!
__________________
1991 ZR-1 #1438 Black/Black & Red |
|
|
|
09-23-2017
|
#2 |
Join Date: Apr 2017
Location: Wayne Illinois
Posts: 396
|
Re: Lumbar Control Bezel Hardware
They take a simple black Phillips head screw, I believe mine were washer head. Snug, but not too tight, the bezel will break.
__________________
 91-#1935 Black/black & gray, Haibeck 500 Cams by Pete |
|
|
|
|
09-24-2017
|
#3 |
|
Join Date: Jul 2015
Location: Ypsilanti, MI
Posts: 116
|
Re: Lumbar Control Bezel Hardware
Thanks! Wasn't sure if it was a tiny bolt or a screw.
Dug through my screw collection and found that the #8 x 1/2" oval head screws fit perfectly for this application.
__________________
1991 ZR-1 #1438 Black/Black & Red |
|
|
|
 |
|
|
Linear Mode
