![]() |
#1 |
Join Date: Oct 2008
Location: tampa
Posts: 539
|
![]()
Picked up some of the OBX headers and need the extension harness, who's got them pre-made?
|
![]() |
![]() |
![]() |
#2 |
Join Date: Oct 2010
Location: Sedalia, MO
Posts: 150
|
![]()
I bought an aftermarket Bosch O2 sensor, it came with an 18 inch leash with a splice connector that worked excellent. did not even have to unplug the old connector which is a bear to get to. You just need it on the passenger side. driver side fits.
![]() ![]() ![]() ![]()
__________________
Fun 91 #303 |
![]() |
![]() |
![]() |
#3 |
![]() Join Date: May 2010
Location: Japan
Posts: 3,567
|
![]()
http://www.zr1products.com/#!products
I bought mine from Randy. If I recall, I bought mine separately and did not need the entire kit.
__________________
Craig "ZR-1 NO KA 'OI" "ZR-1 ICHIBAN" 1995 #228 Black/Black with Dunn Heads ZR-1 owner since September 2003 ZR-1 Net Registry Founding Member #0074 NCM Lifetime Member #2048 ![]() |
![]() |
![]() |
![]() |
#4 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,696
|
![]()
Kurt,
Tell us what you think of the OBX headers? |
![]() |
![]() |
![]() |
#5 |
Join Date: Oct 2008
Location: tampa
Posts: 539
|
![]()
These OBX headers are EXCELLENT quality and value for money, i was very impressed with the welding, as well as the materials used, not to mention they came with all clamps and extensions for the RH side header. The only thing they don't have is the 02 extension.
My customer wanted them jet hot coated bright red, so i sent them to Jethot last week, i'll take somes pics when i get them back, not sure red headers are everyones cup of tea, but i'm sure they will look pretty slick when done. I will not hesitate to sell these in the future, but until my customer actually fits them to his car, i'll hold of endorsing them fully. At this point though, there are people that have installed them and they fit as good as any other headers made. These are made in China, but at this point in time, i often wonder what GM sells themselves that isn't, heck i get AC delco parts all the time and lots of it is stamped MIC. |
![]() |
![]() |
![]() |
#6 |
Join Date: Oct 2010
Location: Sedalia, MO
Posts: 150
|
![]()
My OBX Header installation was easy and a perfect fit. I was a little concerned about how close they were to the steering column so I made a small dent in them to accommodate the column... I probably could have got away without the divot but it would have been close!
__________________
Fun 91 #303 |
![]() |
![]() |
![]() |
|
|