|
06-21-2024
|
#1 |
|
Join Date: Mar 2024
Location: Northeast
Posts: 44
|
Replacing main bearings
I recently discovered a lot of gold glitter after an oil change. The car did briefly make some lifter and/or knocking noise, but that cleared up. There seemed to be sludge in the oil so I changed it. Oil was changed in February by the shop who sold me the car. They used the fram filter, not me. It had maybe 1500 miles on it. Cat has 94k. This what I found. Can the mains be changed from the bottom of the car if the crank journals aren?t damaged?
Last edited by Tim555; 06-21-2024 at 01:33 PM. |
|
|
|
06-22-2024
|
#2 |
 Join Date: Dec 2020
Location: Sydney, Australia
Posts: 86
|
Re: Replacing main bearings
If my car had metal particulate that had circulated through the motor, I'd be doing a full tear down otherwise any fix may be very temporary before any metal particulate left in the motor causes damage again after you change the bearings.
|
|
|
|
|
06-23-2024
|
#3 |
 
Join Date: Apr 2007
Location: Northern VA
Posts: 2,658
|
Re: Replacing main bearings
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
|
|
|
|
06-27-2024
|
#4 |
 
Join Date: Oct 2012
Location: Germany
Posts: 230
|
Re: Replacing main bearings
You can`t change the main bearings if the engine is installed into the car. Unfortunately the engine has to be disassembled on a stand until the last screw. The crankshaft must taken out to replace the main bearings...no other way.
__________________
 Best thing in life is a ZR-1 ride 
|
|
|
|
|
07-01-2024
|
#5 |
Join Date: Dec 2019
Location: st louis mo
Posts: 748
|
Re: Replacing main bearings
if you dont polish the crank,it will take out the bearings in 10 miles
__________________
95 admiral blue z(sold)/ / 93 ruby z(sold) 91 steel blue z/95 aqua z haibeck 510, 91 callaway 415 areobody #5 |
|
|
 |
|
|
Linear Mode
