|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]()
EDIT** everything is out and for sale.
Will be up for sale shortly just wanted to start a thread if thats ok. Had the setup in for about 2k miles. Believed the clutch to be slipping but didnt even drive it since to figure it out since I planned a twin disc replacement anyways. Car still runs and drives and shifts fine. Will make a video today or tomorrow if I can find time to fire it up and idle with clutch in and out to show how quiet and whine free the setup is. Might be keeping the slave cylinder for my 93 Lt1 car. Bearign was brand new when installed in my car. I purchased an old stock clutch setup and kept the bearing and sold the oem pressure plate that was new etc. have pics and documentation to show the purchase etc from ebay. Fidanza $225 oem pp was refurbished by Jim Jandik $100 Plus shipping. Last edited by 5ABI VT; 06-11-2018 at 09:09 PM. |
![]() |
![]() |
![]() |
#2 |
![]() Join Date: Nov 2014
Location: Brooklyn ny
Posts: 1,045
|
![]() |
![]() |
![]() |
![]() |
#3 | |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#4 |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]()
Wanted to bump this instead of making a new thread. Everything is for sale and ready to go.
Some pics right before install and after removal. The flywheel surface was covered in fluid I believe from the Slave. The disc that was removed had literally 0 wear as I only had about 1500-2k km on the setup. Pulled it all due to a little slippage due to oil contamination and decided to just go twin disc and hydraulic t.o bearing conversion from Jerry/Ram. Whole setup before install ![]() LT5 pressure plate ![]() Fidanza/ spec light flywheel ![]() Flywheel after removal ![]() |
![]() |
![]() |
![]() |
#5 |
Join Date: Aug 2014
Location: Maple Park, Il.
Posts: 54
|
![]() |
![]() |
![]() |
![]() |
#6 | |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]() Quote:
![]() |
|
![]() |
![]() |
![]() |
#7 |
Join Date: Aug 2014
Location: Maple Park, Il.
Posts: 54
|
![]()
Sir, Who manufactured the clutch disk and is there a part #
Sent from my SM-G955U using ZR-1 Net Registry mobile app |
![]() |
![]() |
![]() |
#8 | |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#9 |
Join Date: Aug 2014
Location: Maple Park, Il.
Posts: 54
|
![]() |
![]() |
![]() |
![]() |
#10 | |
Join Date: Jun 2013
Location: Toronto
Posts: 783
|
![]() Quote:
![]() |
|
![]() |
![]() |
![]() |
|
|