Rear Suspension Problem

[HIZNHRZ]

Originally Posted by Aurora40

Scott, you may want to look in the FSM. Ride height is not measured in terms of wheelwell gap. You should measure out the appropriate place on the side skirt and measure to the ground.

Bob, I know there are trim dimensions in the FSM but darn if I can find them. Do you know what section they are in?

Originally Posted by HIZNHRZ

I'm not positive the sway bar has been off but Marc Haibeck just put 4:10 gears in it if that tells us anything. Are you thinking it might be flipped 180?

Just for giggles, look in the rear wheel well and see which way the sway bar bends for the last section. You can do it with the car on the ground.

[HIZNHRZ]

Originally Posted by Jeffvette

Just for giggles, look in the rear wheel well and see which way the sway bar bends for the last section. You can do it with the car on the ground.

The stabilizer shaft bends up to connect to the shaft link.

Originally Posted by HIZNHRZ

The stabilizer shaft bends up to connect to the shaft link.

So that would be correct. Let me mull it over tonight.

http://www.pnwzr1.net/Jeff/Coilover/IMG_5420.JPG

[HIZNHRZ]

Originally Posted by Jeffvette

So that would be correct. Let me mull it over tonight.

Thanks Jeff, very much appreciate the help. Look forward to hearing what you come up with.

[Aurora40]

Originally Posted by HIZNHRZ

Bob, I know there are trim dimensions in the FSM but darn if I can find them. Do you know what section they are in?

In my FSM it is on page 3-15, though it just refers to diagrams that are on page 3-21 and 3-22.

[HIZNHRZ]

Originally Posted by Aurora40

In my FSM it is on page 3-15, though it just refers to diagrams that are on page 3-21 and 3-22.

Thanks Bob, I actually did find the info last night. There is also some good info in 10-3-3.