Flywheel and Pressure Plate Bolts:FIDENZA

[zrwhat]

Where is a good source for Flywheel and Pressure Plate bolts when changing over from a Dual Mass to a Fidenza on a LT-5?

What exactly are the difference in their lenghts?

Pressure plate bolts are the same, correct, FW need to be longer, correct?
Thanks.....

[LGAFF]

I believe its 7/16 1.25" bolt for flywheel, I ended up at ACE hardware.

[tf95ZR1]

Good thread to read:

http://www.zr1.net/forum/showthread....a+bolts&page=4

Also SRP products sells a set of bolts.

[Jagdpanzer]

I have an extra set of longer flywheel bolts you can have.

[XfireZ51]

Originally Posted by LGAFF

I believe its 7/16 1.25" bolt for flywheel, I ended up at ACE hardware.

Due to sourcing of Ace bolts, I was advised to avoid using them on the flywheel even if they are Grade 8s.

[LGAFF]

Originally Posted by XfireZ51

Due to sourcing of Ace bolts, I was advised to avoid using them on the flywheel even if they are Grade 8s.

Guy in Freeport builds motors for drag cars and tractors(pulling) told me they are fine.....he uses them..... Guess I will find out.

[XfireZ51]

Originally Posted by LGAFF

Guy in Freeport builds motors for drag cars and tractors(pulling) told me they are fine.....he uses them..... Guess I will find out.

OK! I'll help push your wheelchair.

[LGAFF]

Looked on line, no references to bolt faliures using their stuff. I doubt they are going to put themselves out there for that kind of liability over a 1.50 bolt.

Dist is Hillman

If anyone knows of a first hand example, please share.