|
02-11-2010
|
#1 |
 
Join Date: Apr 2007
Location: Northern VA
Posts: 2,650
|
Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project
Gathering up some parts for my stroker project and looking for a set of 5.850" SBC billet rods, standard LT5 journal size, either new or used if in good condition. Prefer Crower or Oliver but will consider others.
|
|
|
|
02-11-2010
|
#2 |
 Join Date: Sep 2005
Location: Washington
Posts: 955
|
Re: Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project
Oh No...............
Don't do it. 3 years later and I forgot how much$$$ Still dont have my 402. Wait for a good car for sale, with motor work done. |
|
|
|
|
02-11-2010
|
#3 | |
|
Join Date: Apr 2007
Location: Northern VA
Posts: 2,650
|
Re: Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project
Quote:
Sorry, I'm to far along to to pu$$y out now. Already have a spare 4 bolt engine, 4" Bryant crank and JE pistons to start the project off with. After rods the remaining major item will be liners. How about a progress report on your 402 project? Is the shortblock together yet? How is the block and liner clearance on the Crower rods you used? Last edited by Jagdpanzer; 02-11-2010 at 09:43 PM. |
|
|
|
|
|
02-11-2010
|
#4 |
|
Join Date: Sep 2005
Location: Washington
Posts: 955
|
Re: Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project
I used 2.00 Crower's. I'm not 100% sure if the outside dimension is smaller also, compared to the 2.100 rods.
Rod clearance was easy, just a little buff out on the girdle and the bottom of the block (liner). I'm having Jeff run down to where me block/parts are. I hope to know tommrow. I was told it would be ready 2 weeks ago........... 
|
|
|
|
 |
|
|
Linear Mode
