|
09-17-2008
|
#1 |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
U-Joints
What are you guys using for U-joints for the drive & 1/2 shafts? I need to replace mine on the 93 LT1 car... would like USA made if possible.
TIA
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
09-17-2008
|
#2 | |
 
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
|
Re: U-Joints
Quote:
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
|
|
|
|
 |
|
|
Linear Mode
