Fires then dies. HELP - Page 2 - ZR-1 Net Registry Forums

secondchance · 3 Days Ago

Quote:

Originally Posted by Ozruss90

I will try and borrow a fuel pressure gauge to test pressure at the rail, to see what?s going on there.
? reconfiguration of electrical connector ? are you referring to the de pinned plug at the ECM ?

Yes.

Ozruss90 · 4 Hours Ago

Have tested fuel pressure at the rail and showing between 40 and 45 psi. Checked for any faults at the ALD port by bridging A & B. Only getting code 12, so no faults detected.

HELP PLEASE. I have a Corvette function coming up in a couple of weeks and need the Z running.

Question.. Should the engine start and run if the cam angle sensor was faulty ??? I pulled it out again today ( 3rd time ) just to re check, and it looks as good as new.

4 Hours Ago	#12
Ozruss90 Join Date: Oct 2016 Location: Shepparton. Vic. Australia Posts: 146	Re: Fires then dies. HELP Have tested fuel pressure at the rail and showing between 40 and 45 psi. Checked for any faults at the ALD port by bridging A & B. Only getting code 12, so no faults detected. HELP PLEASE. I have a Corvette function coming up in a couple of weeks and need the Z running. Question.. Should the engine start and run if the cam angle sensor was faulty ??? I pulled it out again today ( 3rd time ) just to re check, and it looks as good as new.