WTB: Front license plate ram air intake

[scorp508]

Same.

[aafc]

Sory I'am trying to get my act together
John

[aafc]

Ok let's try this

Photo of square tube feeding stock air box thru the front bumper.



5.5 in opening cut thru front bumper (old A/O forced air intake)



stock air filter with open air lid








Complete cold air system outside of car. The ZR-1 Splash front plate has
been cut out to allow outside air into the sealed modified air box.
The entire air box has been covered with cool tape to reduce engine
compartment heat into the modified air box. To help reduce radiant heat
between the radiaotor shrould and air filter box place a sheet of reflectix
foil installation betwen the radiator and air filter housing.

[-=Jeff=-]

those work

[scorp508]

Originally Posted by -=Jeff=-

Let me know when you get it. I might just need to good pictures and measurements. I don't own a 3D and will need to find where to get it done, but I could probably model it

Jeff, I now have a few parts in hand.

• 84-90 bumper piece with the detachable cross-piece
• 91-96 bumper piece with the detachable cross-piece
• 91-96 air filter box lid (And a 2nd on the way, checking if it is 90-95 ZR1 specific or not)
• The Hose from bumper to air filter box lid.

I also purchased a 3D scanner (love an excuse to buy a tool), so I may be able to get some models. I'm still coming up to speed on the software.

[Vettemann98]

Originally Posted by scorp508

Scott, any chance you still have this? Was it the 84-90 kit, or the 91-96 kit? I have been trying to find an unmangled set of instructions and the cutting templates. I'd be happy to pay shipping to myself in Massachusetts, copy them, and send them right back undamaged. Thank you.

No sorry. scott

[-=Jeff=-]

Originally Posted by scorp508

Jeff, I now have a few parts in hand.

• 84-90 bumper piece with the detachable cross-piece
• 91-96 bumper piece with the detachable cross-piece
• 91-96 air filter box lid (And a 2nd on the way, checking if it is 90-95 ZR1 specific or not)
• The Hose from bumper to air filter box lid.

I also purchased a 3D scanner (love an excuse to buy a tool), so I may be able to get some models. I'm still coming up to speed on the software.

90-96 radiator shroud is the same for ZR-1 and Non-ZR-1

Once you get the scanner and get to know how to use it I would be interested in seeing scans for the 1990-old license plate stuff. I can probably print it but not sure how many pieces I would need to break it into for my printer to handle it