Tensioner pulley

[Wigert]

Hello

A while back I bought the following pulley from rock auto
ACDELCO38015Tensioner Pulley

But I now noticed that it does not have flanges when I stared replacing it. Would this be a bad replacement or should it be fine? Or should I press the bearing out and put it in the old pulley?

Thanks registry for your continues support!

Sent from my EVR-L29 using ZR-1 Net Registry mobile app

[secondchance]

Below is my preference. Powder coated steel with flanges.

https://www.ebay.com/itm/New-Lower-A...72.m2749.l2649

[Wigert]

Originally Posted by secondchance

Below is my preference. Powder coated steel with flanges.

https://www.ebay.com/itm/New-Lower-A...72.m2749.l2649

Hey

I saw this option in another thread but it would take a while to get that one since I live in Sweden... That is why I asked if what I already have would work or not...

Sent from my EVR-L29 using ZR-1 Net Registry mobile app

[secondchance]

What you have should work.

[Wigert]

Originally Posted by secondchance

What you have should work.

I will most likely order the one you suggested later but have to go through inspection soon and would like not to wait.

Thanks for the input!

Sent from my EVR-L29 using ZR-1 Net Registry mobile app