BOSE relay access - ZR-1 Net Registry Forums

Stratos · 11-23-2019

Hi
I have a 1991ZR-1 I am trying to change Bose relay (relay that send 12V to each speaker AMP)

do you have to remove carpeted low dash and aluminum knee bolster both?
Thank You

secondchance · 11-23-2019

If you are referring to CDM, yes. Passenger side.

Z51JEFF · 11-23-2019

If you’re talking about the CDM controller once you get the bush panel off. Take out the pass seat,get on your back,look up into the hole where it resides then relieze what a total pain in the a$$ the jobs going to be and have somebody else do it! I work on my own cars and this was one of the biggest pain in the a$$ I’ve ever done.

billschroeder5842 · 11-23-2019

Mine took over four hours with two weeks of recovery time for contorting my back.

Worst project I ever did on the car.

Dynomite · 11-23-2019

Post 139 - Bose Speaker Amps and CDM Replace

Stratos · 11-23-2019

Thank You for the quick response actually relay that send 12V to each speaker AMP trying to change

geezer · 11-25-2019

Left hand lower trim pad
Driver's knee bolster
relay & wiring cable located at the lower right side of the I/P carrier
push relay & cable away from carrier & pull down from retainer.

11-23-2019	#1
Stratos Join Date: Oct 2019 Location: USA Posts: 2	BOSE relay access(relay that send 12V to each speaker AMP) Hi I have a 1991ZR-1 I am trying to change Bose relay (relay that send 12V to each speaker AMP) do you have to remove carpeted low dash and aluminum knee bolster both? Thank You Last edited by Stratos; 11-23-2019 at 10:03 PM.

11-23-2019	#2
secondchance Join Date: Aug 2006 Location: McLean, VA Posts: 3,707	Re: BOSE relay access If you are referring to CDM, yes. Passenger side.

11-23-2019	#3
Z51JEFF Join Date: Dec 2007 Location: Fremont,Ca Posts: 3,052	Re: BOSE relay access If you’re talking about the CDM controller once you get the bush panel off. Take out the pass seat,get on your back,look up into the hole where it resides then relieze what a total pain in the a$$ the jobs going to be and have somebody else do it! I work on my own cars and this was one of the biggest pain in the a$$ I’ve ever done.

11-23-2019	#4
billschroeder5842 Join Date: Nov 2016 Location: Southlake, TX Posts: 584	Re: BOSE relay access Mine took over four hours with two weeks of recovery time for contorting my back. Worst project I ever did on the car. __________________ Bill Schroeder Texas Proud! 1991 Corvette ZR1 #1388 2015 Challenger Scat Pack Shaker

11-23-2019	#5
Dynomite Join Date: Aug 2009 Location: South Dakota/California Posts: 3,790	Re: BOSE relay access Post 139 - Bose Speaker Amps and CDM Replace __________________ Left Clickable links -Solutions- LT5 Modifications/Rebuild Tricks Low Mileage ZR-1 Restoration 1990 Corvette (L98) Modifications LT5 Eliminated Systems LT5 Added Systems LT5/ZR-1 Fluids 1995 LT5 SPECIFIC TOP END REBUILD TRICKS

11-23-2019	#6
Stratos Join Date: Oct 2019 Location: USA Posts: 2	Re: BOSE relay access Thank You for the quick response actually relay that send 12V to each speaker AMP trying to change

11-25-2019	#7
geezer Join Date: Aug 2010 Location: ottawa canada Posts: 155	Re: BOSE relay access Left hand lower trim pad Driver's knee bolster relay & wiring cable located at the lower right side of the I/P carrier push relay & cable away from carrier & pull down from retainer.