![]() |
#1 |
![]() Join Date: Apr 2019
Location: Supply NC
Posts: 124
|
![]()
Hey guys, I am cleaning my tank today and its pretty bad. I can remove the solids off the liner fairly easy, and there is a lot. My question is how to remove the gummy varnish that has accumulated. I have read a few posts that suggest white vinegar and baking soda and water and another that suggests draino , I don't want to damage the liner in the tank, thanks.
|
![]() |
![]() |
![]() |
#2 |
Join Date: Sep 2017
Location: Iceland
Posts: 46
|
![]()
I think i would just buy a new tank, that looks really bad.
|
![]() |
![]() |
![]() |
#3 |
![]() Join Date: Apr 2019
Location: Supply NC
Posts: 124
|
![]()
Yes Daniel's, it is very bad, the old sending unit assembly dissolved into the tank. This is what happens when machines are neglected. I'm going to work on it for a little while and see. Thanks
|
![]() |
![]() |
![]() |
#4 |
![]() Join Date: Apr 2017
Location: Wayne Illinois
Posts: 397
|
![]()
Looks to me like it is time for a new tank, that one looks to be beyond repair. Looks like maybe the whole fuel system may need replacement.
__________________
![]() 91-#1935 Black/black & gray, Haibeck 500 Cams by Pete |
![]() |
![]() |
![]() |
#5 |
![]() Join Date: Jun 2013
Location: PA
Posts: 879
|
![]()
I'm not sure what all dissolved, but that is a massive amount of solids. You'll have to take that tank out to clean it appropriately anyway, so you might as well put a new tank in.
|
![]() |
![]() |
![]() |
#6 | |
![]() Join Date: Apr 2016
Location: Birmingham, Alabama
Posts: 60
|
![]() Quote:
Ethanol caused problems similar to this when it was first introduced. Older fuel storage tanks had a layer of sludge built up from years of leaded fuel storage. Unleaded fuel didn't seem to affect the sludge but ethanol started dissolving it and it ended up in our fuel tanks. The concentration of sludge that went into your tank was worse if you were unlucky enough to fill up when the storage tank was low. Those fortunate ones who filled up only at newer stations never had to deal with it. It was a black gummy mess that required some serious flushing to eliminate. |
|
![]() |
![]() |
![]() |
#7 |
![]() ![]() Join Date: Jul 2005
Location: San Antonio, TX
Posts: 626
|
![]()
Wow! The change out isn’t too bad, but you will need to remove the rear substructure. A new tank is about $300.
Sent from my iPhone using ZR-1 Net Registry
__________________
Mark Horner President, ZR-1 Net Registry 91 ZR-1 #2016 95 ZR-1 #21 DRM-600, LPE 385 |
![]() |
![]() |
![]() |
|
|