Header install ..... one down 😁

[zr1assassin]

Originally Posted by HAWAIIZR-1

Chris,
You just gotta post that heat shield photo you did on FB! You know the one.....lol!!


Sent from my iPhone using ZR-1 Net Registry

🤣🤣🤣😂😂😂😁😁😁 DONE!

https://ibb.co/cnJQh7

[Paul Workman]

Originally Posted by 1LEZ

All bolts will fit. Did mine last year

Really!?

Mine are early Stainless Works headers. Some primary tubes curved so close to a bolt hole that they prevented a bolt from being inserted into the (1/2" thick) flange. At the time I seem to recall asking someone about it and whomever it was had the same issue and told me not to worry about a couple missing bolts as the flanges were 1/2" thick and wouldn't warp.

Are your headers by SW or OBX?

[HAWAIIZR-1]

Originally Posted by zr1assassin

🤣🤣🤣[emoji23][emoji23][emoji23][emoji16][emoji16][emoji16] DONE!



https://ibb.co/cnJQh7

Ha, ha! I needed a good laugh again!


Sent from my iPhone using ZR-1 Net Registry

[G8nightman]

Originally Posted by Paul Workman

Really!?

Mine are early Stainless Works headers. Some primary tubes curved so close to a bolt hole that they prevented a bolt from being inserted into the (1/2" thick) flange. At the time I seem to recall asking someone about it and whomever it was had the same issue and told me not to worry about a couple missing bolts as the flanges were 1/2" thick and wouldn't warp.

Are your headers by SW or OBX?

Mine are SW

[ALLTHECAMS]

Any tips on removing the heat shields?

Sent from my XT1710-02 using ZR-1 Net Registry mobile app

[zr1assassin]

Originally Posted by ALLTHECAMS

Any tips on removing the heat shields?

Sent from my XT1710-02 using ZR-1 Net Registry mobile app

No way around it.... PITA!
they used sheet metal scores lol

[ALLTHECAMS]

You mean screws?

Sent from my XT1710-02 using ZR-1 Net Registry mobile app

[zr1assassin]

Originally Posted by ALLTHECAMS

You mean screws?

Sent from my XT1710-02 using ZR-1 Net Registry mobile app

Lol ya...fookin auto correct