Rear View Camera Install - ZR-1 Net Registry Forums

XfireZ51 · 02-21-2017

In the process of installing an appradio4 and including backup camera w it.
The camers needs a reverse gear signal to turn it on. There's supposed to be a light green wire for Circuit 239 and its supposed to be below right side of IP.
Anyone have a tip on how to access this wire or where I could find it?

secondchance · 02-21-2017

Quote:

Originally Posted by XfireZ51

In the process of installing an appradio4 and including backup camera w it.
The camers needs a reverse gear signal to turn it on. There's supposed to be a light green wire for Circuit 239 and its supposed to be below right side of IP.
Anyone have a tip on how to access this wire or where I could find it?

Yours is a 92? When I installed back up camera for David J's 94 with Pioneer AVIC 130BH, I think I tapped onto reverse light switch at the transmission. Although I have shop manual for 94, I'll look for light green wire you are asking.

WVZR-1 · 02-21-2017

Quote:

Originally Posted by XfireZ51

In the process of installing an appradio4 and including backup camera w it.
The camers needs a reverse gear signal to turn it on. There's supposed to be a light green wire for Circuit 239 and its supposed to be below right side of IP.
Anyone have a tip on how to access this wire or where I could find it?

That ain't CIRCUIT 239 - that's the C239 connector there at the IP. The circuit is 24 from the switch to the rear of the car. You could access the 24 circuit there or C209 and also at C401. C401 maybe in RH cargo storage bin? I ain't never looked!

This image I don't think is in a '92 FSM but the connector locations I'd think are a match.

C239.png

XfireZ51 · 02-22-2017

Thanks Dave. As usual, always helpful. I did not see that figure in my FSM or the supplement. I'll take a look tomorrow. Crawling under the IP is getting somewhat tougher these days if u know what I mean.

WVZR-1 · 02-22-2017

I would look first for the C401 connector in the RH storage compartment maybe. C401 pinning can be seen 8A-202-15 and you should see LT GRN at M. I'd think much easier access. Closer to the head unit for sure is C209/C239. 8A-202 section for pinning of connectors can be very helpful. 8A-201 and 8A-202 I use a good bit!!

Search LOCOBOB's thread for C401 and C209. He has snapshots of both.

http://www.zr1.net/forum/showthread....401#post188551

XfireZ51 · 02-22-2017

That's excellent Dave. Thanks. Unlike Bob, I have not pulled
my interior apart. Mine is a 92, but I'll look in the rear storage compartment.
After I do my stretching exercises, I could try sticking my head under the IP 😀I'm going to start converting the AVIC harness connector to the appradio.
There's also a MUTE wire. Not sure yet what that's for.

XfireZ51 · 02-22-2017

Dave,

Here's the connector I found that looks similar to the illustration. Looked behind the courtesy light in the pillar, and also the RH Storage bin but did not see anything in either place. Again, mine is a late 92.

GOLDCYLON · 02-22-2017

Dom if my bypass resister arrives in time I will take pics of where I am tied into this weekend. I need to remove a Bluetooth module I left behind as well

WVZR-1 · 02-22-2017

Snapshot is a little small to do anything positive with but if you can ID the cavity it would be easier to confirm for you. From here in the Eastern Panhandle of WV I can't quite see it!!

XfireZ51 · 02-22-2017

Dave,

Its cavity G.

02-21-2017	#1
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,708	Rear View Camera Install In the process of installing an appradio4 and including backup camera w it. The camers needs a reverse gear signal to turn it on. There's supposed to be a light green wire for Circuit 239 and its supposed to be below right side of IP. Anyone have a tip on how to access this wire or where I could find it? __________________ [SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX

02-22-2017	#4
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,708	Re: Rear View Camera Install Thanks Dave. As usual, always helpful. I did not see that figure in my FSM or the supplement. I'll take a look tomorrow. Crawling under the IP is getting somewhat tougher these days if u know what I mean. __________________ [SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX

02-22-2017	#5
WVZR-1 Join Date: Oct 2004 Posts: 1,890	Re: Rear View Camera Install I would look first for the C401 connector in the RH storage compartment maybe. C401 pinning can be seen 8A-202-15 and you should see LT GRN at M. I'd think much easier access. Closer to the head unit for sure is C209/C239. 8A-202 section for pinning of connectors can be very helpful. 8A-201 and 8A-202 I use a good bit!! Search LOCOBOB's thread for C401 and C209. He has snapshots of both. http://www.zr1.net/forum/showthread....401#post188551 Last edited by WVZR-1; 02-22-2017 at 09:33 AM.

02-22-2017	#6
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,708	Re: Rear View Camera Install That's excellent Dave. Thanks. Unlike Bob, I have not pulled my interior apart. Mine is a 92, but I'll look in the rear storage compartment. After I do my stretching exercises, I could try sticking my head under the IP 😀I'm going to start converting the AVIC harness connector to the appradio. There's also a MUTE wire. Not sure yet what that's for. __________________ [SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX

02-22-2017	#7
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,708	Re: Rear View Camera Install Dave, Here's the connector I found that looks similar to the illustration. Looked behind the courtesy light in the pillar, and also the RH Storage bin but did not see anything in either place. Again, mine is a late 92. __________________ [SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX Last edited by XfireZ51; 03-08-2024 at 03:10 PM.

02-22-2017	#8
GOLDCYLON Join Date: May 2007 Location: Peoria, AZ Posts: 9,155	Re: Rear View Camera Install Dom if my bypass resister arrives in time I will take pics of where I am tied into this weekend. I need to remove a Bluetooth module I left behind as well __________________ GOLDCYLON - 91 ZR-1 #2014 GOLDCYLON - 90 ZR-1 #2794, 4L60e (Formerly Schrade's) GOLDCYLON - 11 CTS-V Arizona State Director 91 WHITE/BLACK #2014. 380 P&P&PCed,Ported Heads, Jeal Long tubes, Corsa Exhaust/FIKSE FM-5s /LED TLs, LED Headlights, Front Wilwood 6 piston narrowlite calipers and rear Wilwood caliper street shop mod,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer APP Radio 4,Brey-Krause HB,Sub Bar,Fire extinguisher seat mount,DRM Coilovers,LEDs everywhere,Compass mirror (orange),V1 DIC hidden display, Homelink sun visor, Carbon Fiber top x3 and APSIS Carbon Fiber interior, APSIS CF Steering Wheel/NAPA Leather, Banski trailing arms, Guldstrand front suspension,urethane bushings from Prothane (total suspension) ZFDoc drive shaft safety loop, raptor shift light (orange),AO engineering louver front plate, Console seat cushion, 96CE seats with black custom Sheepskins, ss billet catch can,Viper remote entry/alarm,Cragar Rear Louvers,LED side louver lights, Dewitts Radiator with SPAL fans and a Woods 160 T-Stat 90 RED/BLACK #2794. 4L60e Automatic Stage V by RPM Transmission, TCI Dedicated TCM, OBX Stainless Headers, Corsa Exhaust, SAN Secondaries and Haibeck PROM, Exotic Muscle Coil overs, LED Interior Lights, LED Tail Lights, LED Headlights, 94 Sport seats with black custom Sheepskins , Cragar rear louvers, GS Front calipers, Banski Trailing arms, APSIS Carbon Fiber steering wheel, Front and Rear Baer Eradispeeds, DRLs, Guldstrand front suspension,urethane bushings from Prothane (total suspension), Dewitt's Raditor with Dual SPAL fans and a Haibeck 170 T-Stat 11 RED/GREY CTS-V

02-22-2017	#9
WVZR-1 Join Date: Oct 2004 Posts: 1,890	Re: Rear View Camera Install Snapshot is a little small to do anything positive with but if you can ID the cavity it would be easier to confirm for you. From here in the Eastern Panhandle of WV I can't quite see it!!