|
12-08-2014
|
#1 |
 Join Date: Nov 2013
Location: Satellite Beach
Posts: 33
|
Rear Hub/Bearing Question
I need to replace my rear drivers hub/bearing...have a lot of play and noise. In the FSM diagram it shows a Hub Bearing Seal behind the wheel spindle washer. I contacted a dealer to get these parts and the rep said the bearing seal is no longer listed as a part since it's integrated into the hub replacement. Is this true or is he misled?
Thanks! Rich
__________________
1990 Corvette ZR-1 Polo Green #1648 1979 Trans Am SE Smokey & The Bandit Edition 1975 Porsche 911S (Sold) 1962 Lincoln Continental |
|
|
|
12-09-2014
|
#2 |
 Join Date: Oct 2004
Posts: 1,889
|
Re: Rear Hub/Bearing Question
In '84 & '85 there was a seal behind the hub bearing inner washer. That seal went away in '86 when ABS was introduced. In the FIG#1 image on 3D-2 that is for some reason still displayed (#74) '90 MY FSM, maybe (#73) in later FSM. It would be wise I'd think to consider the replacement of the "inner" washer as "while you're there". GM# 14076924 would get you that washer.
The parts rep's explanation is interesting. It's not correct and you can see in the image is also not even a possibility. It was though a "creative thought" on his/her part! Last edited by WVZR-1; 12-09-2014 at 08:21 AM. |
|
|
|
|
12-09-2014
|
#3 |
|
Join Date: Nov 2013
Location: Satellite Beach
Posts: 33
|
Re: Rear Hub/Bearing Question
You rock! Thanks...is the GM part you're referring to the "Teflon" washer?
__________________
1990 Corvette ZR-1 Polo Green #1648 1979 Trans Am SE Smokey & The Bandit Edition 1975 Porsche 911S (Sold) 1962 Lincoln Continental |
|
|
|
|
12-09-2014
|
#4 | |
|
Join Date: Oct 2004
Posts: 1,889
|
Re: Rear Hub/Bearing Question
Quote:
|
|
|
|
|
 |
|
|
Linear Mode
