Installed No Flex Frame Stiffener Bar System

[ZZZZZR1]

Originally Posted by Billy Mild

Is the member's only section on the ZR1 registry site. How long does it take to sync up the forum with the paid membership.

Jeff,

Saw you just signed up, you should be set up tomorrow.

Will email Brett and Mark.

Thanks for your support! Great meeting you last month!



David

[Billy Mild]

Originally Posted by ZZZZZR1

Jeff,

Saw you just signed up, you should be set up tomorrow.

Will email Brett and Mark.

Thanks for your support! Great meeting you last month!



David

It was nice meeting you as well.

I didn't realize there was a paid subscription before reading this thread. There is a wealth of knowledge here so it is worth supporting this community.

I tried looking for these frame stiffener's on the member's shop, but there wasn't anything listed. Is it the standard discount for paying members at Vette2Vette? Is there a group buy that is going to happen?

[Kevin]

Originally Posted by Billy Mild

It was nice meeting you as well.

I didn't realize there was a paid subscription before reading this thread. There is a wealth of knowledge here so it is worth supporting this community.

I tried looking for these frame stiffener's on the member's shop, but there wasn't anything listed. Is it the standard discount for paying members at Vette2Vette? Is there a group buy that is going to happen?

pretty sure it's a group buy

[92whiteZ]

I couldnt find the group buy on the membership site either. did i miss it?

[ZZZZZR1]

Originally Posted by 92whiteZ

I couldnt find the group buy on the membership site either. did i miss it?

I"ll call Jason @ Vette to Vette and ask him to continue the
group buy.

Cheers

David

[key_on]

I recently installed the No Flex Stiffeners on my car. It is possible that I don't have them adjusted properly yet but they did not help as much as I had hoped. Going to try to tighten them a little more. If I can't obtain better results they're coming off.

[Fully Vetted]

Just make sure they are even on both sides. Count the threads and get as close as you can.

[ZZZZZR1]

Originally Posted by key_on

I recently installed the No Flex Stiffeners on my car. It is possible that I don't have them adjusted properly yet but they did not help as much as I had hoped. Going to try to tighten them a little more. If I can't obtain better results they're coming off.

I'd call Jason @ Vette to Vette

Jason gave a coupon code for club members! Will post in the members only section

Cheers

David