|
05-16-2014
|
#1 | ||
|
Join Date: Dec 2012
Location: NC
Posts: 1,786
|
Does ANYone know...
... what the infamous header stud leak is?
Quote:
__________________
I'm getting my snappics / threads removed blindly as fast as I can, to get in compliance with copyright / license TOS on the boards here (lots of FSM pages and other copyright / license violations on my part; sorry guys). And thanks to all the guys who didn't whine when I posted those FSM copyrighted / licensed stuff in my threads... ( :thumbsup: [b]and to think I complied with a mod's request to delete a pic of him in a Challenge Car in NCM Museum, so he wouldn't get in hot water)[/b] Thanks to several guys here for sending parts FREE; BearlyFlying, WeGone, Geezer, GoldCylon, and more there, TonyD, mike100, fletchusmc... 1990 #2794; 4L60e Stage V by RPM Transmission, TCI Dedicated TCM, OBX Stainless, Power Effects 3" [IMG]https://lh5.googleusercontent.com/-GHpfzty7DVU/UQn-0Ru2xAI/AAAAAAAAA14/08mz1p4QLD4/s445/Screenshot-5.png[/IMG] |
||
|
|
|
05-16-2014
|
#2 |
  
Join Date: Jun 2005
Location: pittsburgh
Posts: 4,633
|
Re: Does ANYone know...
There tends to be a leak around the bolts in the manifolds on the factory system, possibly on aftermarket headers too. Not always but from time to time this will happen.
__________________
It's not the car, it's the people - Doug Johnson 90 r/r "KEYS ON" nick named "T.L.B" |
|
|
|
|
05-16-2014
|
#3 |
 Join Date: Feb 2010
Location: Arvada Colorado
Posts: 194
|
Re: Does ANYone know...
Hey Schrade,
Sounds like you got her about licked. The stud I circled tends to leak. Just tighten two nuts on it against each other so you can remove it. I used some brake clean to clean up the threads and some locktite to seal it. On my car only the right side leaked but I pullled both and seal them while it was apart
__________________
[I]4-cam[/I] [I]1991 ZR-1 Blk/Gry #31[/I] [I]SW Headers/Xpipe- Dynomax Muffs[/I] [I]Ported top end[/I] [I]Secondaries Removed[/I] Tune by Dominic |
|
|
|
 |
|
|
Linear Mode
